User manual SONY MDR-EX700LP

[. . . ] Any outdoor use of this product is prohibited on the French territory (including French overseas departments). Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] Do not carry a battery together with coins or metallic objects. Heat can be generated by the battery if its positive and negative terminals are accidentally shorted. When you are not going to use the unit for a long time, remove the batteries to avoid damage from battery leakage or corrosion. Use the supplied connecting cable (stereo mini-plug y pin plug × 2) when connecting a stereo mini-jack (line out jack or headphone jack) to the LINE IN jacks. To headphones jack (stereo mini jack) Stereo mini-plug Transmitter to headphones jack (stereo phone jack) To LINE IN jacks Audio right (R, red) Audio left (L, white) Unimatch plug adaptor (supplied) In this case, set the volume on the player at a medium level. Noise can occur if the volume on the player is set too low. When connecting to a TV headphone jack, sound may not be heard from the TV speaker. Transmitter To audio output jacks To LINE IN jacks Audio left (L, white) Audio right (R, red) Audio right (red) Audio cord (sold separately) Audio left (white) VCR, TV, or other component Setting the input level If the volume is low using the analogue input, set the ATT (attenuator) switch to "0 dB. TV, portable components, and other components with a low output level Other components (initial settings) Be sure to lower the volume before setting the ATT switch. If audio input to the LINE IN jacks is distorted (sometimes, noise can be heard at the same time), set the ATT switch to "­8 dB. Use the sold separately optical digital connecting cable to connect the optical digital output jack on a CD/DVD device, digital satellite/TV receiver, or other digital component to the DIGITAL IN jack (black) of the transmitter. Note To listen to dual audio (MAIN/SUB) sound sources, connect to the LINE IN jacks, and then select the sound source you want to listen to on the player, TV, or other component. When watching films, be careful not to raise the volume too high in quiet scenes. You may hurt your ears when a loud scene is played. You may hear some noise when you disconnect the AC power adaptor from the transmitter before removing the headphones. The headphones automatically turn off when they are removed -- Auto Power On/Off function Do not pull up the self-adjusting band when not in use, as this will consume the battery power. If a beep sound is heard from the headphones A repeated beep sound is heard if reception conditions deteriorate when the headphones are outside the signal transmission area, or another wireless apparatus using 2. 4 GHz frequency or microwave oven causes interference. If the beep sound does not stop after moving closer to the transmitter, let the transmitter detect the optimum frequency for transmission again following the procedure below. After detection is completed, the RF indicator lights up and emission starts. The beep sound stops when the headphones start receiving signals. The transmitter detects the optimum frequency automatically when the headphones are removed from the transmitter. [. . . ] Bilingual sound cannot be selected when using digital input. (Both MAIN and SUB can be heard at the same time. ) , Connect the analogue out to the LINE IN jacks, and select the sound on the connected component. Cause and remedy , The headphones cannot receive the signal from the transmitter. [. . . ]