User manual SONY MDS-B6P

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the deck, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for the MDS-B6P MiniDisc Deck. [. . . ] Press m/M repeatedly until the track number which will precede the new track flashes. press AMS to display flashing "0 , " then do steps 3 to 5 of "Programming the tracks" on page 25. Press M repeatedly until "0" flashes after the last track number, then do steps 3 to 5 of "Programming the tracks" on page 25. Press m/M repeatedly until the number of the track to be changed flashes, then do steps 3 to 5 of "Programming the tracks" on page 25. Erase all tracks Add a track at the beginning of the program Inserting blanks between tracks during play (Auto Space) The MD deck can be set to automatically insert a threesecond blank between tracks during play. This function is useful when you're recording from an MD to an analog tape since the three-second blank enables you to use the Multi-AMS function later to locate the beginning of tracks on the tape. Add a track in the middle of the program While the deck is stopped, press MENU/NO twice. /> repeatedly) until "Auto" appears, then press AMS or YES. Turn on Auto Space Turn off Auto Space If you select "Auto Space" and record a selection containing multiple track numbers (for example, a medley or symphony), blank spaces will be created on the tape in between the various sections. ⷠIf you turn off the deck or disconnect the AC power cord, the deck will store the last setting ("Auto Space" or "Auto Off") and recall it the next time you turn on the deck. Pausing after each track (Auto Pause) You can set the MD deck so that it pauses after each track to give you time to locate the next track to be recorded. For example, if you erase track number 2, the previous track number 3 becomes track number 2 and the previous track number 4 becomes track number 3, and so on. While the deck is stopped, playing, or paused, press MENU/NO. The deck starts to play the track indicated by the number in the display. /> repeatedly) until the track number you want to erase appears. " appears for a few seconds and the track is erased. The track following the erased track starts to play. If the erased track is the last one on the MD, the track preceding the erased track starts to play. " appears in step 4 above The track has been record-protected on another MD deck. If you still want to erase the track, press AMS or YES again while the indication appears. Z To avoid confusion when erasing more than one track start erasing from the highest numbered track. This way you'll avoid renumbering the tracks that you plan to erase. [. . . ] the program contains the maximum number of tracks. US and foreign patents licensed from Dolby Laboratories Licensing Corporation. Design and specifications are subject to change without notice. If "REMOTE" appears under other circumstances, turn off the deck, then turn it on again. [. . . ]