User manual SONY MDS-DRE1

[. . . ] Caution - The use of optical instruments with this product will increase eye hazard. Do not install the appliance in a confined space, such as a bookcase or build-in cabinet. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. The model and serial numbers are located on the bottom of the unit. [. . . ] Do not turn off the power immediately after recording This may prevent proper recording. If you do, recorded material may not be saved to the MD. when you eject the disc or press ENTER/YES , "TOC Writing" blinks in the display. Wait until "TOC Writing" has finished blinking before pressing U or unplugging the AC power cord from the wall outlet. You can mark a track number manually any time during recording. During recording, press r REC at the point where you want to mark a track number. The unit marks track numbers differently depending on the source being recorded and the type of connections being used. â· When recording from CDs or MDs with this unit's INPUT set to DIGITAL: Track numbers are marked automatically. However, this function may not work properly with some multi disc (and one disc) CD players. Sync On", if the input level drops below a certain level for 1. 5 seconds, the unit marks a new track number the next time it rises back above that level. Sync Off" the unit marks a track number when the recording is started, but no track numbers are marked during recording. The MD cannot be ejected during recording. * The song number changes if you pause during recording. For example, if you pause while recording song 4, the portion recorded after the pause is recorded as song 5. To protect an MD against accidental erasure To make it impossible to record on an MD, slide the tab in the direction of arrow, opening the slot. During stop, recording, or pause, press EDIT/NO twice to display "Setup Menu" Turn AMS to select "L. This unit allows you to record on an MD (from CD, etc. Alternatively, you could connect this unit to a mixer, mix the sound of the MD with the sound of another component, and simultaneously record the mixed sound back to the same MD. During playback, sound is recorded to the blank space on the MD. Make sure the program source is connected and that this unit's INPUT is set correctly before you begin. Z You can determine how the unit will assign new track numbers when you choose "L. [. . . ] Design and specifications are subject to change without notice. You can perform various edit operations on this unit by using the Edit Menu. in addition , the Setup Menu is also located within the Edit Menu. Although each menu operation was explained in previous sections, we have included the chart at right for your reference. [. . . ]