User manual SONY MDS-J3000ES

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the deck, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for the MDS-J3000ES MiniDisc Deck. [. . . ] To enter a track number over 10 Z Use >10. While the deck is stopped and "PROGRAM" lights up, do steps 1 and 2 of "Programming the tracks" on page 25, followed by one of the procedures below: To Press m/M repeatedly until the number of the unwanted track flashes, then press CLEAR. Press CLEAR repeatedly until all the track numbers disappear. Press m repeatedly until "0" flashes before the first track number, then do steps 3 to 5 of "Programming the tracks" on page 25. Press m/M repeatedly until the track number which will precede the new track flashes. press AMS to display flashing "0 , " then do steps 3 to 5 of "Programming the tracks" on page 25. Press M repeatedly until "0" flashes after the last track number, then do steps 3 to 5 of "Programming the tracks" on page 25. Press m/M repeatedly until the number of the track to be changed flashes, then do steps 3 to 5 of "Programming the tracks" on page 25. Erase all tracks Add a track at the beginning of the program Inserting blanks between tracks during play (Auto Space) The MD deck can be set to automatically insert a threesecond blank between tracks during play. This function is useful when you're recording from an MD to an analog tape since the three-second blank enables you to use the Multi-AMS function later to locate the beginning of tracks on the tape. Add a track in the middle of the program While the deck is stopped, press MENU/NO twice. when "TOC Writing" flashes in the display The deck is updating the TOC. Do not disconnect the AC power cord or move the deck while the indication flashes. Specify the number of the track you want to erase. When you erase a track, all the tracks after the one erased are automatically renumbered. For example, if you erase track number 2, the previous track number 3 becomes track number 2 and the previous track number 4 becomes track number 3, and so on. While the deck is stopped, playing, or paused, press MENU/NO. The deck starts to play the track indicated by the number in the display. /> repeatedly) until the track number you want to erase appears. " appears for a few seconds and the track is erased. The track following the erased track starts to play. If the erased track is the last one on the MD, the track preceding the erased track starts to play. [. . . ] , There has been a power failure or the AC power cord has been disconnected during recording. The deck does not perform Synchro-recording with a CD player or video CD player. , The remote supplied with the MD deck is not set correctly. If the deck does not operate properly even after you've attempted the prescribed remedies, turn off the deck, then reinsert the plug into the power outlet. [. . . ]