User manual SONY MDS-JE500

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ] The program remains even after Program Play ends when you press · , you can play the same program again. Press PLAY MODE repeatedly (or PROGRAM once) until "PROGRAM" appears in the display when the deck is stopped. Do either a) or b): a) When using the remote Press the number buttons to enter the tracks you want to program in the order you want. To program a track with a number over 25, use the >25 button (see page 17). If you've made a mistake Press CLEAR, then press the right number button. B) When using the controls on the deck 1 Turn AMS until the track number you want appears in the display. Each time you enter a track, the total program time is added up and appears in the display. Press PLAY MODE repeatedly (or CONTINUE once) when the deck is stopped until "PROGRAM" disappears. The program created by the Program Play Function is lost when you turn off the deck or disconnect the AC power cord. The program is, however, recalled during timer playback. The display shows "- -m - -s" instead of the total playing time when the total playing time of the program exceeds 160 minutes. You can check the order of tracks in your program during playback or playback pause. Turn AMS (or press = or +) during playback or playback pause. The track numbers appear in the order they were programmed. You can change the order of the tracks in your program before you start playing. to Erase the last track in the program Add tracks to the end of the program Change the whole program completely Each time you press the button, the last track will be cleared. For further information on connecting the timer or setting the starting and ending times, refer to the instructions that came with the timer. The Auto Space and Auto Pause Functions described in this section make recording from MDs to tape more easy. The Auto Space Function inserts a 3-second blank space between each track while recording from MDs to tapes, allowing you to use the AMS function during later playback. Press PLAY MODE repeatedly (or one of the PLAY MODE buttons once) to select the play mode you want. To play only specific tracks, create a program (see page 20). If you want to specify the time for both start and end of playback, go to Step 4. [. . . ] The deck does not work during synchro-recoding. /The currently selected CD player type (CD player or Video CD player) does not match the CD player being used. If you experience any of the following difficulties while using the deck, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. [. . . ]