User manual SONY MDS-JE520

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The use of optical instruments with this product will increase eye hazard. The model and serial numbers are located on the rear of the unit. record these numbers in the spaces provided below. [. . . ] You can specify tracks during Shuffle Play ⷠTo play the next track, turn AMS clockwise (or press +). ⷠTo play from the beginning of the current track again, turn AMS counterclockwise (or press =). You cannot use AMS (or =) to go to tracks that have already been played. While the deck is stopped, press MENU/NO twice to display "Setup Menu". 1 Turn AMS until the track number you want appears in the display. If you enter the wrong track number Press 0 or ) until the wrong track number flashes, turn AMS to set the correct track number, then press AMS. Press the number buttons to enter the tracks you want to program in the order you want. To program a track with a number over 25, use the >25 button (see page 20). While the deck is stopped and "PROGRAM" is on, press LEVEL/DISPLAY/CHAR (or DISPLAY) several times. The track numbers appear in the order they were programmed as follow: "/3 / 5 / 8 / 1 / 2/" If you enter the wrong track number Press 0 or ) until the wrong track number flashes, then enter the correct track number with the number buttons. You can scroll the display to check all the track numbers you programmed. The entered track is added to the location where the "0" flashes. Each time you enter a track, the total program time is added up and appears in the display. You can change the order of the tracks in your program before you start playing. To Do the following procedure after Steps 1 and 2 in "Creating Your Own Program": A track Press 0 or ) until the track number you want to erase flashes, then press CLEAR. Keep pressing CLEAR until all programmed track numbers disappear. 1 Press 0 until "0" flashes at the left of the first track. 1 Press 0 or ) until the track which precedes the track to be added flashes. 1 Press 0 or ) until the track number you want to change flashes. Press PLAY MODE repeatedly (or CONTINUE once) when the deck is stopped until "PROGRAM" disappears. The whole program to the beginning of the program in the middle of the program The program remains even after Program Play ends when you press · , you can play the same program again. The display shows "- -m - -s" instead of the total playing time when the total playing time of the program exceeds 199 minutes. [. . . ] This MD deck uses the Serial Copy Management System, which allows only first-generation digital copies to be made of premastered software via the deck's digital input jack. an outline of this system appears below: 1 You can record from digital program sources (CDs, DATs or premastered MDs) onto a DAT tape or recordable MD via digital input jack on the DAT or MD deck. You cannot, however, record from this recorded DAT tape or MD onto another DAT tape or recordable MD via the digital input jack on the DAT or MD deck. 2 You can record the digital input signal of a digital satellite broadcast onto a DAT tape or recordable MD via the digital input jack on the DAT or MD deck which is capable of handling a sampling frequency of 32 kHz or 48 kHz. [. . . ]