User manual SONY MDS-JE530

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Before operating the deck, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for the MDS-JE530 MiniDisc Deck. conventions · Controls in these instructions are those on the deck; these may, however, be substituted by controls on the supplied remote that are similarly named, or, when different, appear in the instructions within parentheses. [. . . ] while editing , press to cancel editing. AMS control: Turn to select an editing operation or track number, then press to enter your selection. You can also use the control to specify points in a track for erasure or track division. YES button: Press this button instead of the AMS control to enter a selection. M/M buttons: Press to specify the unit (minute, second, or frame) by which the MD is advanced when the AMS control is turned. You can also use these buttons to locate the end point of the portion to be erased. For further details on the function of each button and control, see the sections on editing operations. About indication which appears while editing You can erase a track or part of a track simply by specifying the number of the track or the portion within a track to be erased. About indications which appear after editing When "TOC" lights up in the display Editing has finished but the TOC (Table of Contents) on the MD has not been updated to reflect the editing results. The editing will be lost if you disconnect the mains lead while the indication is on. The TOC will be updated only when you eject the MD or turn off the MD deck. when "TOC Writing" flashes in the display The deck is updating the TOC. Do not disconnect the mains lead or move the deck while the indication flashes. Specify the number of the track you want to erase. When you erase a track, all the tracks after the one erased are automatically renumbered. For example, if you erase track number 2, the previous track number 3 becomes track number 2 and the previous track number 4 becomes track number 3, and so on. While the deck is stopped, playing, or paused, press MENU/NO. The deck starts to play the track indicated by the number in the display. /> repeatedly) until the track number you want to erase appears. " appears for a few seconds and the track is erased. The track following the erased track starts to play. If the erased track is the last one on the MD, the track preceding the erased track starts to play. [. . . ] (The message flashes for about four seconds when you turn on the deck by pressing +/1. You tried to start Programme Play when no programme exists. An attempt was made to record on a premastered MD. the programme contains the maximum number of tracks. [. . . ]