User manual SONY MDS-S37

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. [. . . ] The program created by the Program Play Function is lost when you turn off the deck or disconnect the AC power cord. ⷠThe display shows "- -m - -s" instead of the total playing time when the total playing time of the program exceeds 160 minutes. Press PLAY MODE repeatedly (or PROGRAM once) until "PROGRAM" appears in the display when the deck is stopped. Do either a) or b): a) When using the remote Press the number buttons to enter the tracks you want to program in the order you want. To program a track with a number over 25, use the >25 button (see page 16). If you've made a mistake Press CLEAR, then press the right number button. B) When using the controls on the deck 1 Turn AMS until the track number you want appears in the display. Each time you enter a track, the total program time is added up and appears in the display. Press PLAY MODE repeatedly (or CONTINUE once) when the deck is stopped until "PROGRAM" disappears. You can check the order of tracks in your program during playback or playback pause. Turn AMS (or press = or +) during playback or playback pause. The track numbers appear in the order they were programmed. You can change the order of the tracks in your program before you start playing. to Erase the last track in the program Add tracks to the end of the program Change the whole program completely Each time you press the button, the last track will be cleared. You can edit the recorded tracks after recording, using the following functions: · Erase Function allows you to erase recorded tracks simply by specifying the corresponding track number. ⷠDivide Function allows you to divide tracks at specified points so that you can quickly locate those points afterwards, using the AMS function. ⷠCombine Function allows you to combine two consecutive tracks into one. ⷠMove Function allows you to change the order of tracks by moving a specific track to a track position you want. ⷠTitle Function allows you to create titles for your recorded MDs and tracks. if "Protected" appears in the display The deck could not edit because the record-protect slot on the MD is open. The Auto Space and Auto Pause Functions described in this section make recording from MDs to tape more easy. The Auto Space Function inserts a 3-second blank space between each track while recording from MDs to tapes, allowing you to use the AMS function during later playback. [. . . ] 6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. And foreign patents licensed from Dolby Laboratories Licensing Corporation. Design and specifications are subject to change without notice. Your deck can output various beeps to allow you to verify deck operations by sound. [. . . ]