User manual SONY MDS-S39

[. . . ] The following caution label is located inside the apparatus. Controls in these instructions are those on the deck; these may, however, be substituted by controls on the supplied remote that are similarly named, or, when different, appear in the instructions within parentheses. Don't throw away the battery with general house waste, dispose of it correctly as chemical wastes. 12 -- Recording for long times/Marking track numbers/Smart Space/Adjusting the recording level/Checking the remaining recordable time/Input monitor Starting recording with 6 seconds of prestored audio data -- Time Machine Recording . [. . . ] /> repeatedly) while monitoring the sound, and then press AMS or YES when you locate the desired ending point. you can shift the point by 1-frame2) intervals (1 frame = 1/86 second). You can shift the point by 2-frame intervals on the track recorded in Monaural mode or LP2 Stereo mode, and by 4-frame intervals on the track recorded in LP4 Stereo mode. " alternate in the display and the deck repeatedly plays a few seconds of the track before the point A. In steps 5 and 7, if you want to shift point A or point B by a certain number of seconds or minutes, press m/M repeatedly. You can change the unit by which the counter advances when you turn AMS (or press . This happens when you have edited the same track many times. This is due to a technical limitation of the MD system and is not a mechanical error. You can use this function to mark track numbers after recording. The total number of tracks increases by one and all the tracks following the divided ones are renumbered. Example: Dividing track 2 into two tracks. This is a technical limitation of the MD system and is not a mechanical error. You can use this function to change the order of any track on the disc. When you move tracks, the tracks are automatically renumbered. You can enter a name for a recorded MD as well as for individual tracks. Names can consist of uppercase and lowercase letters, numbers, and symbols. A total number of about 1, 700 characters can be stored for all the names on the MD. The following procedure is for entering names when the Group function is off. to name a group , see "Naming a group" on page 33. However, when naming an MD recorded using the Group function, be sure to name the disc with the Group function on so as not to rewrite the group management information by mistake. 1 While the deck is stopped, playing, or Repeatedly) until the number of the track to be moved appears, then press AMS or YES. If you name a track while it is being recorded, be sure to finish the naming operation before the track ends. [. . . ] , Check the connection or turn the digital component back on. You pressed NET MD during Check In or Check Out. An attempt was made to edit the MD during Programme or Shuffle Play or to change the recording level of an MD recorded in LP2 or LP4 Stereo mode. There is an error in the internal data that the deck needs in order to operate. [. . . ]