User manual SONY MDS-S40

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] /> repeatedly) until "Auto" appears, then press AMS or YES. Turn on Auto Pause Turn off Auto Pause If you turn off the deck or disconnect the AC power cord, the deck will store the last setting ("Auto Pause" or "Auto Off") and recall it the next time you turn on the deck. This chapter explains how to edit the tracks that have been recorded on an MD. The buttons and the control below are used to erase, divide, move, or combine tracks on the MD. note The operation of these buttons and the control is different when naming a track or MD. MENU/NO button: While the deck is stopped, playing, or paused, press to edit tracks. while editing , press to cancel editing. AMS control: Turn to select an editing operation or track number, then press to enter your selection. You can also use the control to specify points in a track for erasure or track division. YES button: Press this button instead of the AMS control to enter a selection. M/M buttons: Press to specify the unit (minute, second, or frame) by which the MD is advanced when the AMS control is turned. You can also use these buttons to locate the end point of the portion to be erased. For further details on the function of each button and control, see the sections on editing operations. About indication which appears while editing You can erase a track or part of a track simply by specifying the number of the track or the portion within a track to be erased. About indications which appear after editing When "TOC" lights up in the display Editing has finished but the TOC (Table of Contents) on the MD has not been updated to reflect the editing results. The editing will be lost if you disconnect the AC power cord while the indication is on. The TOC will be updated only when you eject the MD or turn off the MD deck. when "TOC Writing" flashes in the display The deck is updating the TOC. Do not disconnect the AC power cord or move the deck while the indication flashes. Specify the number of the track you want to erase. When you erase a track, all the tracks after the one erased are automatically renumbered. For example, if you erase track number 2, the previous track number 3 becomes track number 2 and the previous track number 4 becomes track number 3, and so on. [. . . ] The following table provides a quick guide to the various editing functions that you can perform using the Edit Menu. The available menu items may vary according to the current status of the deck. The following table provides an overview of the various Setup Menu items, including their parameters, factory settings, and reference page(s) in the manual. To access the Setup Menu While the deck is stopped, press MENU/NO twice to display "Setup Menu. [. . . ]