User manual SONY MDS-SP55

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The following caution label is located inside of the unit. Here are some of the features you can use with this MD deck when connected with the CMT-SP55TC Micro Hi-Fi component system (see page 4). The MD deck power is tied with the CMT-SP55TC Micro Hi-Fi component system. [. . . ] During MD play or playing pause or while selecting a track t Indicates that the track being played back or the selected track is recorded in monaural format. Turn FUNCTION on the amplifier until "MD" appears. Press MENU/NO in stop mode to display "MD Edit Menu", and turn l/L until "MD Setup ?Turn l/L until "MD Stereo Rec" (or "MD Mono Rec") appears, then press ENTER/YES. Turn l/L until "MD Mono Rec" appears, then press ENTER/YES. Turn FUNCTION to select the desired sound source (e. By using the editing functions, you can create a new sequence to the recorded MD. You can edit an MD only when: · Check the following, before editing. You can use upper case, lower case, numbers, and symbols for the titles. ⷠErase -- Erasing recordings (page 31) Use this function to erase a single track one by one, all the tracks at once, or a portion of a track. ⷠMove -- Changing the order of tracks (page 34) Use this function to change the track numbering. ⷠDivide -- Adding track numbers (page 35) Use this function to add track numbers. This lets you locate your favourite phrases quickly. ⷠCombine -- Combining recorded tracks (page 37) By using this function, two tracks are combined to a single track. You can combine the tracks which are not numerically consecutive, i. ⷠUndo -- Cancelling the last edit (page 38) Use this function to cancel the last edit and restore the contents of the MD to the condition before the edit. You can edit the MD only in normal play mode. "TOC" lights up or starts flashing. Before pulling out the mains lead Do not pull out the mains lead before updating the TOC (while "TOC" is lit) or while updating the TOC (while "TOC" is flashing) to ensure a complete editing. You can create titles for your recorded MDs and tracks as follows. Or > until the desired track number appears. If "CD-TEXT" flashes in the display during recording a CD, you can record the CD disc title on the MD (see page 16). [. . . ] ⷠMD recording and editing contents are recorded to the MD when the MD is removed, so make sure you remove the MD after recording or editing (see pages 11 and 28). Replace the MD with a recordable MD, or use the Erase function to erase unnecessary tracks (see pages 31 ­ 34). The sound from an MD you recorded is too low (or too high). C12/Cannot Copy You tried to record a CD or MD with a format that the system does not support, such as a CDROM. [. . . ]