User manual SONY MDS-JA20ES

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] The program remains even after Program Play ends When you press (, you can play the same program again. The display shows "- -m - -s" instead of the total playing time when the total playing time of the program exceeds 199 minutes. 1 Turn AMS until the track number you want appears in the display. If you enter the wrong track number Press 0 or ) until the wrong track number flashes, turn AMS to set the correct track number, then press AMS. While the deck is stopped and "PROGRAM" is on, press DISPLAY/CHAR (or DISPLAY) several times. The track numbers appear in the order they were programmed as follow: "/3 / 5 / 8 / 1 / 2/" You can scroll the display to check all the track numbers you programmed. You can change the order of the tracks in your program before you start playing. To Do the following procedure after Steps 1 and 2 in "Creating Your Own Program": A track Press 0 or ) until the track number you want to erase flashes, then press CLEAR. Keep pressing CLEAR until all programmed track numbers disappear. 1 Press 0 until "0" flashes at the left of the first track. 1 Press 0 or ) until the track which precedes the track to be added flashes. 1 Press 0 or ) until the track number you want to change flashes. The Auto Space Function inserts a 3-second blank space between each track while recording from MDs to tapes, allowing you to use the AMS function during later playback. While the deck is stopped, press MENU/NO twice to display "Setup Menu". Turn AMS to select "Setup 04", then press AMS. Turn AMS to select "Auto Space", then press AMS. You can turn on the Auto Space Function using the remote Z While the deck is stopped, press A. The whole program Add a track to the beginning of the program in the middle of the program 1 Do Steps 1 and 2 in "Inserting blank spaces while recording to tape" on this page. If the Auto Space Function is on while recording a selection containing multiple track numbers, (for example, a medley or symphony), blank spaces will be inserted within the selection whenever the track number changes. Pausing after each track (Auto Pause) When the Auto Pause Function is on, the deck pauses after playing each track. Auto Pause is convenient when recording single tracks or multiple, nonconsecutive tracks. Select "Auto Pause" instead of "Auto Space" in Step 3 on "Inserting blank spaces while recording to tape" on page 30. [. . . ] an outline of this system appears below: 1 You can record from digital program sources (CDs, DATs or premastered MDs) onto a DAT tape or recordable MD via digital input jack on the DAT or MD deck. You cannot, however, record from this recorded DAT tape or MD onto another DAT tape or recordable MD via the digital input jack on the DAT or MD deck. 2 You can record the digital input signal of a digital satellite broadcast onto a DAT tape or recordable MD via the digital input jack on the DAT or MD deck which is capable of handling a sampling frequency of 32 kHz or 48 kHz. You can then record the contents of this recorded DAT tape or MD (first-generation) onto another DAT tape or recordable MD via digital input jack on the DAT or MD deck to create a second-generation digital copy. [. . . ]