User manual SONY MDS-JE510

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The use of optical instruments with this product will increase eye hazard. ⷠShould any solid object or liquid fall into the cabinet, unplug the deck and have it checked by qualified personnel before operating it any further. Before operating the deck, check that the operating voltage of the deck is identical with your local power supply. [. . . ] If you turn off the deck or disconnect the AC power cord, the deck will recall the last setting of the Repeat Function the next time you turn on the deck. The A-B Repeat settings, however, are lost. You can specify tracks during Shuffle Play ⷠTo play the next track, turn AMS clockwise (or press +). ⷠTo play from the beginning of the current track again, turn AMS counterclockwise (or press =). You cannot use AMS (or =) to go to tracks that have already been played. You can program the same track repeatedly You can specify the playback order of the tracks on an MD and create your own programs containing up to 25 tracks. While the track number appears in the display, press AMS as many times as you want. The program remains even after Program Play ends when you press fl (or · ), you can play the same program again. The program created by the Program Play Function is lost when you turn off the deck or disconnect the AC power cord. ⷠThe display shows "- -m - -s" instead of the total playing time when the total playing time of the program exceeds 160 minutes. Press PLAY MODE repeatedly (or PROGRAM once) until "PROGRAM" appears in the display when the deck is stopped. Parts of a track Note, however, that once erased, MD data cannot be recovered. Pausing after each track (Auto Pause) When the Auto Pause Function is on, the deck pauses after playing each track. Auto Pause is convenient when recording single tracks or multiple, nonconsecutive tracks. If you turn off the deck or disconnect the AC power cord, the deck will recall the last setting of the Auto Space and Auto Pause Functions the next time you turn on the deck. You can erase a track simply by specifying the respective track number. When you erase a track, the total number of tracks on the MD decreases by one and all tracks following the erased one are renumbered. Since erasing merely updates the TOC, there is no need to record over material. To avoid confusion when erasing multiple tracks, you should proceed in order of high to low track number to prevent the renumbering of tracks that have not been erased yet. While the deck is stopped, press EDIT/NO repeatedly until "All Erase ?When the disc name, all recorded tracks, and titles on the MD have been erased, "Complete" appears for a few seconds and the music calendar disappears. Turn AMS until the track number you want to erase appears in the display. [. . . ] If the deck does not operate properly even after you've attempted the prescribed remedies, turn off the power, then reinsert the plug into the power outlet. Out and leave the deck in a warm place for several hours until the moisture evaporates. Slide the MD into the disc compartment with the label side up and the arrow pointing towards the opening until the deck grips it. /The MD may not be recorded (the music calendar does not appear). [. . . ]