User manual SONY MDS-S707

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You can change the order of the tracks in your program before you start playing. to Add tracks to the end of the program Change the whole program completely For further information on connecting the timer or setting the starting and ending times, refer to the instructions that came with the timer. Note, however, that programs eventually fade away when the standby status is off, and therefore if you set the time too far in the future, the program may be gone when the specified time arrives. If this has occurred, the deck enters normal play mode at the specified time and the tracks play in consecutive order. Press PLAY MODE repeatedly to select the play mode you want. To play only specific tracks, create a program (see page 21). If you want to specify the time for the end of playback, press fl to start playback, then go to Step 4. ⷠIf you want to specify the time for both start and end of playback, go to Step 4. When you have set the time for the start of playback, the deck turns off. When the specified time arrives, the deck turns on and starts playing. When the specified time arrives, the deck stops playing and turns off. ⷠWhen you have set the time for both the start and end of playback, the deck turns off. When the starting time arrives, the deck turns on and starts playing. When the ending time arrives, the deck stops playing and turns off. After you have finished using the timer, set TIMER on the deck to OFF. You can edit the recorded tracks after recording, using the following functions: · Erase Function allows you to erase recorded tracks simply by specifying the corresponding track number. ⷠDivide Function allows you to divide tracks at specified points so that you can quickly locate those points afterwards, using the AMS function. ⷠCombine Function allows you to combine two consecutive tracks into one. ⷠMove Function allows you to change the order of tracks by moving a specific track to a track position you want. ⷠTitle Function allows you to create titles for your recorded MDs and tracks. if "Protected" appears in the display The deck could not edit because the record-protect slot on the MD is open. You can erase a track simply by specifying the respective track number. [. . . ] ⷠRecording over a track to eliminate noise is not recommended since this may shorten the duration of the track. ⷠYou may find it impossible to label a track while recording over it. The correct recorded/playing time may not be displayed during playback of monaural-format MDs. / Strong magnetism from a television or a similar device is interfering with operations. [. . . ]