User manual SONY MDX-100

[. . . ] * Functions available with optional CD/MD unit Tuning up for your best sound Listening to each programme source in its registered DSO -- Source Sound Memory (SSM) . Card remote commander RM-X111 In menu mode, the currently selectable button (s) of these four are indicated with a " v" in the display. Note If the unit is turned off by pressing (OFF) for 2 seconds, the unit cannot be operated with the card remote commander unless (SOURCE) on the unit is pressed, or a disc is inserted to activate the unit first. The corresponding buttons of the unit control the same functions as those on the card remote commander. [. . . ] When you preset RDS stations, the unit stores each station's AF/TA setting (on/off) as well as its frequency. Some services have not been sufficiently defined or are presently being tested. At present, such services are not supported by the optional DAB tuner unit XT100DAB. DAB programmes are broadcast in Band-III (174 to 240 MHz) and L-Band (1, 452 to 1, 492 MHz), with each band divided into channels (41 in Band-III and 23 in L-Band). Following procedure is available after presetting the service. " Press and hold either side of (SEEK) until "Seek +" or "Seek ­" appears. Tip There is another way to receive the preset service (preset on numbers 1 to 6). Press the number button ((1) to (6)) on which the desired service is stored. The unit will stop seeking when an ensemble is located. The unit will then automatically select the first service and display its name, and the display indicator will change from "Seek +"/"Seek ­" to the service name. Refer to the level indication to check the receiving condition of the DAB programme. Press M or m repeatedly until the desired service appears, then press (ENTER). Press M or m until the desired component appears, then press (ENTER). When you perform the BTM function for the first time, all the ensembles available in your area are automatically stored. When you perform the BTM function again, the contents of these lists are updated in accordance with the conditions described on page 23. An ensemble is added to the respective list when it is received during Automatic Tuning or Manual Tuning but is unlisted. an ensemble is also deleted from the respective list when: · You select an ensemble from the list, but it cannot be received. You perform Automatic Tuning or Manual Tuning to receive a listed ensemble, service, or the component, but it cannot be received. You can use the PTY (Programme type selection) function to tune in the programme you want. Also, if you turn on the DRC (Dynamic Range Control) function, the dynamic range on the service which supports DRC can automatically be extended. The following items can be set: · DRC -- to turn on or off the function. Note "BLGL" appears in the menu only when the unit is receiving a multi-channel programme. [. . . ] see "Cleaning the connectors" (page 36) for details. Stored stations and correct time are erased. Makes noise when the ignition key is in the ON, ACC, or OFF position. Cannot turn off the "--------" indication. [. . . ]