User manual SONY MDX-60

[. . . ] Bend these claws outward for a tight fit, if necessary. The numbers in the list are keyed to those in the instructions. When the installation and connections are completed, be sure to press the reset button with a ballpoint pen, etc. Handle the bracket carefully to avoid injuring your fingers. [. . . ] Handle the bracket carefully to avoid injuring your fingers. The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer to the connection and operating procedures. problem · Memorised stations and correct time are erased. Makes noise when the ignition key is the ON, ACC and OFF positions. No power is being supplied to the unit. Cause Leads are not matched correctly with the car's accessory power connector. The power aerial does not have a relay box. This unit is designed for negative ground 12 V DC operation only. Be careful not to pinch any wires between the screw and the body of the car, or this unit, or between any moving parts such as the seat railing, etc. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. Switched power supply geschaltete Stromversorgung alimentation commutée alimentazione commutata geschakelde voeding ground Masse masse terra aarding Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear. Auxiliary power connector may vary depending on the car. Check your car's auxiliary power connector diagram to make sure the connections match correctly. there are three basic types (illustrated below). [. . . ] Auxiliary power connector may vary depending on the car. Check your car's auxiliary power connector diagram to make sure the connections match correctly. there are three basic types (illustrated below). You may need to switch the positions of the red and yellow leads in the car stereo's power connecting cord. [. . . ]