User manual SONY MDX-C5970

[. . . ] FM/AM MiniDisc Player Operating Instructions US Owner's Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. MDX-C5970 Serial No. For installation and connections, see the supplied installation/connections manual. MDX-C5970 © 1999 by Sony Corporation Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Press (LIST) to display the memorized names. 12 Changing the operative direction The operative direction of controls is factoryset as in the illustration below. To increase Attenuating the sound Press (ATT) on the optional rotary commander. To restore the previous volume level, press (ATT) again. To decrease If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction. Tip The unit decreases the volume automatically when a telephone call comes in (Telephone-ATT function). Changing the sound and display settings You can set: · Clock (page 7). · D. Info (dual information) ­ to display the clock and the play mode at the same time (on) or to display the information alternately (off). · Dimmer ­ to change the brightness of the display. -- Select "Auto" to dim the display only when you turn the lights on. -- Select "on" to dim the display. -- Select "off" to deactivate Dimmer. · Contrast ­ to adjust the contrast if the indications in the display are not recognizable because of the unit's installed position. · Beep ­ to turn the beep tones on or off. · RM (Rotary Commander) ­ to change the operative direction of the controls of the optional rotary commander. -- Select "norm" to use the optional rotary commander as the factory-set position. -- Select "rev" when you mount the rotary commander on the right of the steering column. · M. dspl (Motion display) ­ to turn the motion display 1, 2, or off. · A. Scrl (Auto Scroll) (page 8, 15). Press (SOUND) for two seconds while pushing the VOL control. Tip You can also change the operative direction of these controls with the unit. Adjusting the sound characteristics You can adjust the bass, treble, balance and fader. Each source can store the bass and treble levels independently. 1 Select the item you want to adjust by pressing (SOUND) repeatedly. VOL (volume) n BAS (bass) n TRE (treble) n BAL (left-right) n FAD (front-rear) 2 Adjust the selected item by rotating the dial. Adjust within three seconds after selecting the item. (After three seconds, the dial functions reverts to volume control. ) 1 2 Press (SHIFT). Press (2) (SET UP) repeatedly until the desired setting mode appears. Each time you press (2) (SET UP), the item changes as follows: Clock n D. Info* n Dimmer n Contrast n Beep n RM n M. dspl n A. Scrl* * When no MD or CD is playing, this item will not appear. continue to next page n 13 Note The displayed item will differ depending on the source. With Optional Equipment 3 Press (4) (n) to select the desired setting (Example: on or off). For the "Contrast" setting, pressing (4) (n) makes the contrast higher, and pressing (1) (N) makes the contrast lower. After the mode setting is complete, the display returns to normal playback mode. CD/MD Unit This unit can control a maximum of seven external CD/MD units in this configuration: CD unit ­ maximum of five MD unit ­ maximum of five Any combination up to seven will work. [. . . ] ·Rotate the dial in a clockwise direction to adjust the volume. · The power cord or battery has been disconnected. · The reset button has been pressed. n Store again into the memory. The contents of the memory have been erased. Indications do not appear in the Remove the front panel and clean the connectors. [. . . ]