User manual SONY MDX-C7900R

[. . . ] Where the temperature can also be excessive. When you connect the master unit containing custom file function but no MD button to a CD changer (If your master unit has the SOURCE button, see the master unit's manual Operating Instructions) Even if you try to label the disc using the custom file function, "FULL" appears and you cannot label disca with personalized names. Wipe the surface of the MD cartridge from time to time with a soft dry cloth. The model and serial numbers are located on the bottom of the unit. [. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In this case, remove the MD and wait for about an hour until the moisture evaporates. Always use the unit with the door closed. Otherwise, foreign matter may enter the unit and contaminate the lenses inside the changer. The MD changer compartment has a built in light for easy use even in the dark. * Only available when connected to a main unit that supports this function. About one minute after opening the door, the inside compartment will be lit. Note When an MD is inserted and the door is closed, or the reset button of the connected car audio is pressed, the unit will be automatically activated and read the information on the MDs. The use of optical instruments with this product will increase eye hazard. Under the passenger's seat or floor installation/Installation sous le siège du passager ou sur le plancher/ Instalación en el suelo o debajo del asiento del pasajero/ Decide on the installation position, and remove any dirt or stains from that surface. Place the changer onto the mounting pad 2, then peel the backing and stick 2 to the floor. Avoid installing the unit in a place: -- subject to temperatures exceeding 55°C (131°F) (such as in a car parked in direct sunlight). Choose the mounting location carefully, observing the following: -- The fuel tank should not be damaged by the tapping screws. -- There should be no wire harnesses or pipes under the place where you are going to install the unit. -- The spare tire, tools or other equipment in or under the trunk should not be interfered with or damaged by the screws or the unit itself. Before installing in a glove box or on a console box, be sure the installation will not interfere with the master unit's cords and cables, and that the installation belt does not prevent the cover from opening. Make cuts in the carpet with a box knife. Note For connecting two or more changers, the XA-C30 source selector (optional) is necessary. [. . . ] Note For connecting two or more changers, the XA-C30 source selector (optional) is necessary. * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block. Glove box or console box installation/Installation dans une boîte à gants ou sur un boîtier de console/ Instalación en la guantera o en la tapa de la consola/ Tear off the backing, and attach the double-sided adhesive tapes 3 to the bottom of the unit. Remove any dirt or stains from the surface you're going to mount the unit on, then attach the unit. [. . . ]