User manual SONY MDX-C7970R

[. . . ] This unit lets you enjoy a variety of features as well as a supplied rotary commander and an optional wireless remote. In addition to the MD playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. When you operate this unit or a connected optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play a CD TEXT disc*2. *1 You can connect an MD changer, CD changer and MD player, or CD player. [. . . ] notes · "NO TP" flashes for five seconds if the received station does not broadcast traffic announcements. Then, the unit starts searching for a station that broadcasts it. When "EON" appears with "TP" in the display, the current station makes use of broadcast traffic announcement of other stations in the same network. The "REG on" (regional on) function lets you stay tuned to a regional programme without being switched to another regional station. (Note that you must turn the AF function on. ) The unit is factory preset to "REG on, " but if you want to turn off the function, do the following. During radio reception, press (SHIFT), then press (4) (PLAY MODE) repeatedly until "REG" appears. Note that selecting "REG off" might cause the unit to switch to another regional station within the same network. To return to regional on, select "REG on" in step 2 above. When the unit finds the programme, the programme type appears again for five seconds. "NO" and the programme type appear alternately for five seconds if the unit cannot find the programme type. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. Using the rotary commander the rotary commander works by pressing buttons and/or rotating controls. You can control an optional CD or MD unit with the rotary commander. During radio reception, press (SHIFT), then press (3) (SET UP) repeatedly until "CT" appears. The CT function may not work even though an RDS station is being received. There might be a difference between the time set by the CT function and the actual time. Each time you press (SOURCE), the source changes as follows: Tuner n CD* n MD * If the corresponding optional equipment is not connected, this item will not appear. Pressing (MODE) changes the operation in the following ways: Rotate and hold the control until you locate the specific point in a track, then release it to start playback. If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction. Press (SOUND) for two seconds while pushing the VOL control. Tip You can also change the operative direction of these controls with the unit (page 19). [. . . ] Press the clip inside the front cover with a thin screwdriver, and lever the front cover free. Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. Outputs Line outputs (2) Power aerial relay control lead Power amplifier control lead Telephene ATT control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander (1) Wireless remote RM-X47 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (10 discs) CDX-828, CDX-727 MD changer (6 discs) MDX-65 Source selector XA-C30 And foreign patents licensed from Dolby laboratories Licensing Corporation. [. . . ]