User manual SONY MDX-C8500X

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. [. . . ] Be sure not to start the engine of your car again during Timer-off recording. When an optional TV/video unit is connected, the monitor stays on during Timer-off recording or REC Continue mode. Turn the monitor off before leaving the car to reduce the likelihood of battery drain or theft. â· Frequent use of the Timer-off recording feature may cause battery drain. Make sure that the battery is well charged. â· The power antenna remains extended during Timer-off recording. The sound of the radio will be recorded on the MD as you hear it during reception (including any noise, distortion, and missing sound). Do not edit the MD while driving, as it diverts your attention from the road. Once you finish editing an MD, be sure the MD is ejected before you turn the ignition off or disconnect the power-supply leads of the unit. Editing is completed when the unit updates the TOC (Table of Contents) information and ejects the MD. The lamp located at the bottom of the MD slot flashes during updating of the TOC information. By using the Divide (see page 24), Erase (see page 22), and Combine (see page 25) functions, you can erase specific portions of a track. Original tracks Divide track A into three parts. Original tracks Divide track 2 into tracks B and C. While playing an MD you want to edit, press (MENU). Press either side of (DISC/PRST) repeatedly until "Divide" appears. Press either side of (SEEK/AMS) repeatedly to select the track you want to divide. The unit repeatedly plays the next few seconds after the marked point. While monitoring the track, press (ENTER) at the point where you want to divide. While playing the MD you want to edit, press (MENU). Press either side of (DISC/PRST) repeatedly until "Combine" appears. Press either side of (SEEK/AMS) repeatedly to select the set of tracks you want to combine. [. . . ] You have performed the recording while the unit was subject to excessive vibration (while driving on a rough road, etc. Cannot turn off the "--------" indication. Connect a power antenna control lead (blue) or accessory The sound is hampered by power supply lead (red) to the power supply lead of a car's noises. The power antenna remains extended even when you turn off the ignition. [. . . ]