User manual SONY MEX-DV1700U

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. [. . . ] ·METAL (Metal) lets you play a metal or CrO2 tape. ·BL SKP (Blank Skip) skips blanks longer than eight seconds. Each time you press (MODE), the band changes as follows: B FM1 B FM2 B FM3 AM2 b AM1b 3 4 Press (MENU), then press either side of (PRST/DISC) repeatedly until "BTM" appears. The unit stores stations in the order of their frequencies on the number buttons. A beep sounds when the setting is stored. Notes · The unit does not store stations with weak signals. If only a few stations can be received, some number buttons will retain their former setting. · When a number is indicated in the display, the unit starts storing stations from the one currently displayed. 11 Receiving the memorized stations 1 2 3 Press (SOURCE) repeatedly to select the tuner. Press (MODE) repeatedly to select the band. Press the number button ((1) to (6)) on which the desired station is stored. If FM stereo reception is poor -- Monaural Mode 1 2 During radio reception, press (MENU), then press either side of (PRST/DISC) repeatedly until "MONO" appears. Press (+) side of (SEEK/AMS) until "MONO-ON" appears. The sound improves, but becomes monaural ("ST" disappears). Note When installing in a car without ACC (accessory) position on the ignition key switch, press (OFF) for two seconds to turn off the clock display after turning off the engine. 14 Adjusting the sound characteristics You can adjust the bass, treble, balance, and fader. You can store the bass and treble levels independently for each source. Changing the sound and display settings The following items can be set: · CLOCK (page 8). · BEEP ­ to turn the beep sound on or off. · RM (Rotary Commander) ­ to change the operative direction of the rotary commander. -- Select "NORM" to use the rotary commander as the factory-set position. -- Select "REV" when you mount the rotary commander on the right side of the steering column. · D. INFO (Dual Information)*1 ­ to display the clock and the play mode simultaneously (ON), or to display the information alternately (OFF). · M. DSPL (Motion Display) ­ to turn the motion display on or off. · A. SCRL (Auto Scroll)*2 (page 17). 1 Select the item you want to adjust by pressing (SOUND) repeatedly. Each time you press (SOUND), the item changes as follows: VOL (volume) t BAS (bass) t TRE (treble) t BAL (left-right) t FAD (front-rear) 2 Adjust the selected item by pressing either side of (SEEK/AMS). When adjusting with the rotary commander, press (SOUND) and rotate the VOL control. 1 2 Press (MENU). [. . . ] Remove the front panel and clean the connectors. See "Cleaning the connectors" (page 21) for details. The contents of the memory have been erased. Indications do not appear in the display. Tape playback Problem The sound is distorted. Cause/Solution The tape head is contaminated. [. . . ]