User manual SONY MEX-N4100BT

[. . . ] 4-548-379-22(1) Bluetooth® Audio System Operating Instructions Bedienungsanleitung Mode d’emploi Istruzioni per l’uso Gebruiksaanwijzing GB DE FR IT NL For the connection/installation, see page 28. To cancel the demonstration (DEMO) display, see page 17. MEX-N5100BT/MEX-N4100BT For safety, be sure to install this unit in the dashboard of the car as the rear side of the unit becomes hot during use. For details, see “Connection/Installation” (page 28). [. . . ] ) FIRMWARE Checks/updates the firmware version. For details, visit the following support site: http://support. (Available only while the source is off and the clock is displayed. ) The volume level is adjustable in 1 dB steps, from -6 dB to +6 dB. POSITION (listening position) F/R POS (front/rear position) Simulates a natural sound field by delaying the sound output from speakers to suit your position:  [FRONT L] (front left),  [FRONT R] (front right),  [FRONT] (center front),  [ALL] (center of your car), [OFF] (no position set) ADJ POSITION* (adjust position) Fine-tunes the listening position setting: [+3] – [CENTER] – [-3]. DSEE (digital sound enhancement engine) Improves digitally compressed sound by restoring high frequencies lost in the compression process. This setting can be memorized for each source other than the tuner. AAV (advanced auto volume) Adjust the playback volume level of all playback sources to the optimum level: [ON], [OFF]. RB ENH (rear bass enhancer) Rear Bass Enhancer enhances the bass sound by applying a low pass filter setting to the rear speakers. This function allows the rear speakers to work as a subwoofer if one is not connected. Sound Setup (SOUND) This setup menu is available when any source except for the BT phone is selected. MEGABASS (mega bass) Reinforces bass sound in synchronization with the volume level: [ON], [OFF]. AUDIO+ (ClearAudio+) Reproduces sound by optimizing the digital signal with the Sony recommended sound settings: [ON], [OFF]. (Automatically sets to [OFF] when [EQ10 PRESET] is changed and/or [MEGABASS] is set to [ON]. ) EQ10 PRESET Selects an equalizer curve from 10 equalizer curves or off: [OFF] , [R AND B] , [ROCK] , [POP] , [DANCE] , [HIP-HOP] , [ELECTRONICA] , [JAZZ] , [SOUL] , [COUNTRY] , [CUSTOM]. The equalizer curve setting can be memorized for each source. SW DIREC (subwoofer direct connection) You can use the subwoofer without a power amplifier when it is connected to the rear speaker lead. ) Be sure to connect a 4 – 8 ohm subwoofer to either of the rear speaker leads. Do not connect a speaker to the other rear speaker lead. HPF SLOP (high pass filter slope) Selects the HPF slope (effective only when [HPF FREQ] is set to other than [OFF]): [1], [2], [3]. AUX VOL (AUX volume level) Adjusts the volume level for each connected auxiliary device: [+18 dB] – [0 dB] – [-8 dB]. This setting negates the need to adjust the volume level between sources. [. . . ] Ύ 32GB  Catch  2 Mount the unit onto the bracket , then attach the protection collar . Ύ    Notes  If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Ώ Make sure the 4 catches on the protection collar  are properly engaged in the slots of the unit. Detaching and attaching the front panel For details, see “Detaching the Front Panel” (page 6). [. . . ]