User manual SONY MHC-771

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Note on CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820­40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. CAUTION The use of optical instruments with this product will increase eye hazard. [. . . ] Make sure the tabs on the cassette have not been removed. Then, press § OPEN/CLOSE again to close the disc tray. If the button for the disc tray containing the CD you want to record is not lit green, press DISC SKIP EX-CHANGE repeatedly so that it lights green. After about 10 seconds, the CD starts playing. After about 10 seconds, the CD starts playing. Each time you press CHECK, the number of the programmed tracks appear in the display. To cancel time edit Press on the CD player and then press PLAY MODE. You can have the stereo system create programs based on the tape length. The CD player makes programs that will fit the tape length. For example, if you use a 40-minute tape to record a 46-minute CD, the CD player will automatically choose tracks that will fit within the 40-minutes, filling as much of the tape as possible. The player will not program those tracks beyond track Choose "HALF" if you want the CD player to play just half the total playing time of the CD without changing the order of the track. As you turn the JOG dial or press the or on the remote, the indication changes as follows: To select the desired tracks beforehand You can place priority on some tracks to be recorded by selecting them before programming (only up to 20 tracks). To cancel program edit Press PLAY MODE repeatedly until "PROGRAM" disappears from the display. When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR B" appears in the display after step 8. The chosen track number lights up in the music calendar and is memorized. If the track number disappears before you press ENTER/NEXT, go back to step 5. When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR B" appears in the display after step 11. You can adjust the total recording time to the tape length while making a program. Use the buttons on both the unit and the remote to do this operation. And 4 to 6 from another CD to program the remaining tracks you want to record on side A in the order you want them to be recorded. You can record from the tuner onto a tape. And 4 to 6 from another CD to program the remaining tracks you want to record on side B in the order you want them to be recorded. [. . . ] When a power interruption occurs for longer than half a day, set music clips, timer settings and tuner presetting again. There is an obstacle between the remote and the system. To clean the tape heads and tape path Contaminated tape heads cause poor recording or sound drop-out in playback. We recommend cleaning after every 10 hours of operation. [. . . ]