User manual SONY MHC-D90AV

[. . . ] The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Turn the jog dial until the desired track appears in the display. Disc number Total playing time (including selected track) "STEP" and the programmed playing order appear, followed by the total playing time. Skip step 4 to select tracks from the same disc. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. Repeat steps 5 and 6 for tracks from the same disc or steps 4 to 6 for tracks from another disc to program the remaining tracks to be recorded on side B. After inserting a CD, press EDIT once, so that "EDIT" flashes. The required tape length for the currently selected CD appears, followed by the total playing time and tracks for side A and side B. Select a (or RELAY) to record on both sides. You cannot use this function after programming. In order to use this function, you must first erase the program (see "To clear the entire program" on page 26). After the last track, "CHECK END" appears. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. With the loop function, you can repeat part of a CD during playback. This lets you create original recordings. With the flash function, you can "flash" the CD sound during playback. This lets you create original recordings. Press and hold LOOP during playback at the point you want to start the Loop function, and release to resume normal play. Press and hold FLASH during playback at the point you want to start the Flash function, and release to resume normal play. Turn the jog dial while holding LOOP (or press MUSIC MENU B or b while holding LOOP on the remote) to select different loop lengths (LOOP 1~20). Turn the jog dial while holding FLASH (or press MUSIC MENU B or b while holding FLASH on the remote) to select different flash lengths (FLASH 1~20). To use LOOP and FLASH together The loop and flash length cannot be adjusted during this operation. [. . . ] Move the microphone away form the speakers or change the direction of the microphone. Turn off the TV set once, then turn it on after 15 to 30 minutes. Sound comes from one channel or unbalanced left and right volume. The sound comes from the center speaker only. [. . . ]