User manual SONY MHC-DX10

[. . . ] The model and serial numbers are located on the rear panel of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Use manual or automatic tuning in step 2. To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down TUNER/BAND, turn the system back on. When you change the interval, all the AM preset stations are erased. When an FM stereo program has static noise, press STEREO/MONO repeatedly until "MONO" appears. The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs. With the side you want to play/record facing forward. Searching for the beginning of the current or the next track (AMS)* To go forward You can use TYPE I (normal) tape. To play both decks in succession, press PLAY MODE on the remote repeatedly until "RELAY" (Relay Play)* appears in the display. The AMS function may not operate correctly under the following circumstances: ­ When the unrecorded space between songs is less than 4 seconds long. * After the playback of the front side of deck A, deck B plays the front side, then stops. You can record from a CD, tape or radio. the recording level is adjusted automatically. Steps Recording from a CD (CD Synchro Recording) Load a recordable tape into deck B. Load the CD or tape, or tune in the station you want to record. Press REC PAUSE/START, and then start playing the desired source. You cannot listen to other sources while recording. For recording from the radio: If noise is heard while recording from the radio, move the respective antenna to reduce the noise. You can record a preset radio station from a specified time. To timer-record, you must first preset the radio station (see "Presetting radio stations" on page 12) and set the clock (see "Setting the time" on page 9). When the recording starts, the volume level is set to minimum. Or > repeatedly to set the hour, then press ENTER on the remote. [. . . ] Press DISPLAY twice when the system is turned off. The power cord is disconnected or a power failure occurs longer than half a day. Turn off the TV set once, then turn it on after 15 to 30 minutes. Insert only the stripped portion of the speaker cord into the SPEAKER jack. [. . . ]