User manual SONY MHC-RX110AV

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This caution label is located inside the unit. This stereo system is equipped with the Dolby Btype noise reduction system and Dolby Pro Logic Surround decoder*. [. . . ] With the drum pads, you can add percussion during playback. This effect can be used with any source, to create original recordings. Turn the jog dial while holding PAD A or B (or press SELECT > or . While holding PAD A or B on the remote) to select the sound you desire. You can select from a variety of different drum sounds. Hold down both PAD A and B on the front panel. Each time you press the button the level changes as follows: Using the beat functions With the beat functions, you can enjoy a variety of rhythms. They can be used with any source, to create original recordings. Turn the jog dial while holding BEAT SPEED (or press SPEED ?Turn the jog dial while holding BEAT SELECT (or press SELECT > or . Make sure the button's indicator turns off. Each time you press the button the level changes as follows: LEVEL 1 / LEVEL 2 / LEVEL 3 / LEVEL MAX / LEVEL 1 . You can use the drum pads and the beat function together. Press DEMO while the power is on to hear all drum sounds and beat patterns played repeatedly. Press any (except BEAT LEVEL) key to stop. This function automatically synchronizes the sounds of PAD A and B with the sound source. This function automatically synchronizes the rhythm of the current beat pattern with the sound source. Every time you press the button, the display changes as follows: Once measured, the indicator lights green. This mode emphasizes the rhythm of the source by playing the sound stored at PAD A in sync with the bass and playing the sound stored at PAD B in sync with the treble. The rhythm of the beat pattern starts in sync with the source. If the downbeat of the rhythm does not match the source, press BEAT ON/OFF to turn the beat off. Then, in time with the source, press BEAT ON/OFF again to restart the beat. [. . . ] There is no sound from the center speaker. There is no sound from the rear speakers. The software being played back has limited sound effects. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. [. . . ]