User manual SONY MHC-RXD10AV

[. . . ] 3-865-612-14(1) Mini Hi-Fi Component System Operating Instructions Owner's Record The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. _______________ MHC-GRX90AV / RXD10AV ©1999 by Sony Corporation 1 WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. [. . . ] Note You cannot use this function after programming. In order to use this function, you must first cancel the program by pressing PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. To check the order Press CHECK on the remote repeatedly. After the last track, "CHECK END" appears. To cancel Program Edit Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. Tip When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR" appears after pressing CD SYNC. 29 DJ Effects Looping part of a CD -- Loop With the loop function, you can repeat part of a CD during playback. This lets you create original recordings. (Power) Flashing part of a CD -- Flash With the flash function, you can "flash" the CD sound during playback. This lets you create original recordings. (Power) LOOP Jog dial FLASH Jog dial / Press and hold LOOP during playback at the point you want to start the loop function, and release to resume normal play. To adjust the loop length Turn the jog dial while holding LOOP (or press SELECT > or . while holding LOOP on the remote) to select different loop lengths (LOOP 1~20). / Press and hold FLASH during playback at the point you want to start the flash function, and release to resume normal play. To adjust the flash length Turn the jog dial while holding FLASH (or press SELECT > or . while holding FLASH on the remote) to select different flash lengths (FLASH 1~20). To use LOOP and FLASH together Press and hold both LOOP and FLASH at the same time. Notes · The loop and flash length cannot be adjusted during this operation. Adjust the loop and flash lengths independently beforehand if necessary. · To record the flash effect, use the analog (MD OUT) connections or this unit's tape deck. 30 Sound Adjustment Adjusting the sound You can reinforce the bass, create a more powerful sound, and listen with headphones. (Power) GROOVE SYNC BASS For the most suitable bass sound (SYNC BASS) Press SYNC BASS. The bass frequencies of the music you are listening to are measured and those areas with heavy bass tones are effectively reinforced. The indicator SYNC BASS H or SYNC BASS L lights up according to the areas with heavy bass tones. Press SYNC BASS again to return to the previous level. For a powerful sound (GROOVE) Press GROOVE. The volume switches to power mode, DBFB is automatically set to full strength, the equalizer curve changes, and GROOVE button lights up. Press GROOVE again to return to the previous volume. Notes · With some songs, the music will sound distorted when you use the DBFB system with the sound effect if the bass is too strong. Set the DBFB to " " or "OFF", or cancel the sound effect (page 32). · Cancelling GROOVE sets DBFB to " " and flattens the equalizer curve. To cancel the DBFB level, press DBFB until the indication disappears. FILE SELECT DBFB To listen through the headphones Connect the headphones to PHONES jack. [. . . ] Eject the tape and turn the power back on. Tuner Severe hum or noise ("TUNED" or "STEREO" flashes in the display). ·The signal strength is too weak. A stereo FM program cannot be received in stereo. ·Press STEREO/MONO so that "STEREO" appears. If other troubles not described above occur, reset the system as follows: 1 Unplug the power cord. [. . . ]