User manual SONY MHC-RXD5

[. . . ] * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. "DOLBY" and the double-D symbol a are trademarks of Dolby Laboratories Licensing Corporation. US and foreign patents licensed from Dolby Laboratories Licensing Corporation. 38 Recording only the first track on each CD . [. . . ] Marking track numbers at a specific point while recording You can mark track numbers at any time while recording, regardless of the type of sound source. In this way, a track number is marked only at the beginning. note You cannot mark track numbers automatically if the sound source to be recorded is noisy (e. Press r REC while recording at the point you want to add a track mark. Marking track numbers automatically while analog recording Track numbers are automatically marked when the input signal continues to be under a certain level for more than two seconds and then returns to the previous level. You can monitor the signal being input to the MD deck without recording it. This lets you adjust the recording level of analog sources. When you edit recorded tracks, there is no need for copying the MD. To change the order of tracks Use the Move Function (see page 47) to change the track numbering. This lets you erase a single track one by one or all tracks at once. To locate the beginning of a specific phrase Use the Divide Function (see page 48) to add track numbers. Turn SELECTOR until the track number you want to move appears. You can use this function to add track numbers to multiple tracks that are recorded as one track. This function also lets you mark track numbers after the recording ends. The total number of tracks increases by one and all the tracks following the divided ones are renumbered. Example: Dividing track 2 into tracks B and C. 2 While monitoring the sound, turn SELECTOR to the starting point to be divided. You can check the display and shift the point between ­128 and +127 (±01 is about 0. Press ENTER/YES again when you find the point to be divided. "Complete" appears for a few seconds and the newly created track begins playing. You can also divide tracks while recording. The new track will have no track title even if the original track was labeled. [. . . ] Move the system away from the TV or VCR. Make sure the Dolby NR setting matches the setting used when the tape was recorded. Move the system away from the TV, VCR or power amplifier. One of the following messages may appear or flash in the display during MD operation. [. . . ]