User manual SONY MHC-1750

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To record non-preset stations, use ­ and + (0/ ) on the remote) in step 2 to tune in the desired station. If noise is heard while recording from the radio, move the respective antenna to reduce the noise. You can play the reverse side only on deck B. With the side you want to play facing forward Pressing TAPE A (, TAPE B ( or TAPE B 9 when the system is off automatically turns the system on and starts tape playback if there is a tape in the deck (One Touch Play). You can switch from another source to the tape deck just by pressing TAPE A (, TAPE B ( or TAPE B 9 (Automatic Source Selection). Searching for the start of the current or the next track (AMS*) To go forward Press + during play when the ( indicator is lit. "TAPE A (or TAPE B) >>> +1" appears. Press =** during play when the 9 indicator is lit. Press TAPE B 9 (DECK B ( again on the remote) to play the reverse side. Press = during play when the ( indicator is lit. "TAPE A (or TAPE B) <<< ­1" appears. Press FUNCTION repeatedly until "CD" appears in the display, then place CDs on the disc tray. "1 DISC" shuffles the CD whose disc tray number is displayed. "J" appears and then all the tracks play in random order. You can make a program of up to 32 tracks from all the CDs in the order you want them to be played. Press FUNCTION repeatedly until "CD" appears in the display, then place CDs on the disc tray. Press = or + repeatedly until the desired track appears in the display. Total playing time Disc number (including selected track) The track is programmed and the program step number appears. Skip step 3 to select tracks from the same disc. The program you made remains in the CD player even after it has been played back. --" appears instead of the total playing time during programming, this means: ­ you have programmed a track number which exceeds 20, or ­ the total playing time has exceeded 100 minutes. All the tracks play in the order you selected. [. . . ] Make sure to clean the tape heads before you start an important recording or after playing an old tape. Use separately sold dry-type or wet-type cleaning cassette. The display starts flashing as soon as you plug in the power cord even though you haven't turned on the system (demonstration mode). Press DISPLAY/DEMO when the system is turned off. [. . . ]