User manual SONY MHC-2200CD

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This caution label is located inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] â· You cannot listen to other sources while recording. Press TUNER/BAND repeatedly until the band you want appears in the display. Every time you press the button, the band changes as follows: FM ~ AM Automatic tuning Press and hold 0 or ) in step 2 until the frequency indication starts to change, then release it. Pressing TUNER/BAND when the power is off automatically turns the power on and tunes in the last received station (One Touch Play). â· You can switch from another source to the radio just by pressing TUNER/BAND (Automatic Source Selection). You can record the radio program on a tape by calling up a preset station. With the side you want to record on facing forward To record non-preset stations, use 0 and ) in step 2 to tune in the desired station. â· If noise is heard while recording from the radio, move the respective antenna to reduce the noise. With the side you want to play facing forward When the tape in deck B finishes playing, the tape in deck A starts playing. If you play both decks at the same time, you will hear the sound from deck B. With the side you want to play/record on facing forward This function lets you repeat a single CD or all CDs in normal play, Shuffle Play and Program Play. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. The tracks play in the order you selected. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. Note that you cannot use Tape Select Edit for discs containing over 20 tracks. The CD player starts playing the tracks to be recorded on side A. When the last track for side A finishes playing, the CD player changes to playing pause automatically. Remove the tape from deck A, and insert it again with the side B facing forward. The CD player starts playing the tracks to be recorded on side B. You cannot use this function after programming. In order to use this function, you must first erase the program (see "Clear the entire program" in the table on page 20). If the disc number you want to record is not displayed, press DISC SKIP repeatedly so that it appears. [. . . ] â· Unplug the system from the wall outlet (mains) if it is not to be used for an extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Should any solid object or liquid fall into the component, unplug the stereo system and have the component checked by qualified personnel before operating it any further. â· The AC power cord must be changed only at the qualified service shop. [. . . ]