User manual SONY MHC-991AV

[. . . ] An amplifier that lets you adjust the audio quality to fit a variety of music types and environments · A timer that lets you set the CD player, tape player or radio to turn on and off whenever you want · A dual tape deck that lets you record from the radio, CD player or from the other tape deck and relay play from both decks · A CD player that lets you play up to three CDs in a row and seamlessly advance (or reverse) through all the tracks on all the discs on the CD tray · A music clip feature, that lets you create groups of favourite tracks from your CDs · A remote that lets you control your system from your seat The MHC-991AV consists of the following: - Amplifier/Tuner : STR-W55 - CD Player/Stereo cassette deck : HCD-W55 - Speaker System : SS-EX55D - Remote Control : RM-SW55 Do not, under any circumstances, place the CD player/Tape deck on top of the Amplifier/Tuner. This caution label is located inside the unit. NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] If the button for the disc tray containing the CD you want to record is not lit green, press DISC SKIP repeatedly so that it lights green. After about 10 seconds, the CD starts playing. Each time you press CHECK, the number of the programmed tracks appear in the display. On the remote) to choose the indication that corresponds to the length (in minutes) of your tape. You can adjust the total recording time to the tape length while making a programme. To cancel time edit Press p on the CD player, then press PLAY MODE. To select the desired tracks beforehand You can record certain tracks (up to 20) first by selecting them before time editing. Choose "HALF" if you want the CD player to half of the total playing time of the CD. You cannot select "HALF" when recording CDs with more than 20 tracks. When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR B" appears in the display after step 8. 6 To record on both sides, press EDIT If you only want to record on side A, press p on the CD player to stop the flashing in the display. Each time you press CHECK, the number of the programmed tracks appear in the display. To cancel programme edit Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. 2 Press TUNER/BAND several times until Tape in deck A with the side you want to play facing forward. Also, insert a blank tape in deck B with the side you want to record on facing forward. Recording and playback start from the front side of the tape, unless you change the playing direction before recording. Make sure the tabs on the cassette have not been removed. When you want to dub only part of the tape, dub manually at normal speed. 2 Choose how you want the tape to record When dubbing tapes originally recorded with Dolby NR B, the dubbed tape is automatically recorded with Dolby NR B. When you want to record a tape recorded without Dolby NR B onto another tape using Dolby NR B, press DOLBY NR so that "DOLBY NR B" appears in the display before recording. When the tape in one deck comes to the end of the front side, it reverses immediately regardless of the tape position in the other deck. When the tape in one deck reaches its end of the front side, it stops until the other tape come to its end, and then both tapes reverse together. [. . . ] Contact the radio station and find out whether they actually provide the RDS service. If so, it may be temporarily out of order. When you are using a TYPE II (CrO2) or TYPE IV (metal) cassette, be careful not to cover the detector slots which allow the tape player to automatically detect the type of tape. The tape does not record nor playback or there is a decrease in sound level. [. . . ]