User manual SONY MHC-ZX10

[. . . ] 4-227-887-13(1) Mini Hi-Fi Component System Operating Instructions Owner's Record The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. _______________ MHC-ZX10 ©2000 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. [. . . ] For example, you can record just the songs you want or record from the middle of the tape. The recording level is adjusted automatically. ?/1 (Power) 4 5 6 7 Press MODE SELECT repeatedly to select "Set Up Mode", then press PUSH ENTER. Move the multi stick toward b or B repeatedly to select "TAPE Set Up ?", then press PUSH ENTER. Move the multi stick toward b or B repeatedly to select "Direction Set Up ?", then press PUSH ENTER. Move the multi stick toward b or B repeatedly to select "1 Way" to record on one side, or "Cycle" ( or "Relay") to record on both sides, then press PUSH ENTER. Press REC PAUSE/START. Recording starts. 2 x Multi stick PUSH ENTER 4 8 9 To Start playing the source to be recorded. Press x. REC PAUSE/START. Stop recording Pause recording To cancel the menu operation Press MODE SELECT. 3, 8 . > 1 2 3 Insert a recordable tape into deck B. 1 Press FUNCTION repeatedly until the source you want to record (e. g. , CD) appears. Press REC PAUSE/START. Deck B stands by for recording. The TAPE B N indicator (for front side) lights. 26 Tips · If you want to record from the reverse side, press TAPE B n to light its indicator after pressing REC PAUSE/START in step 3. · When you want to reduce the hiss noise in low-level high-frequency signals, do the following procedure after pressing REC PAUSE/START in step 3. 1 Press MODE SELECT repeatedly to select "Set Up Mode", then press PUSH ENTER. 2 Move the multi stick toward b or B repeatedly to select "TAPE Set Up ?", then press PUSH ENTER. 3 Move the multi stick toward b or B repeatedly to select "DOLBY NR Set Up ?", then press PUSH ENTER. 4 Move the multi stick toward b or B repeatedly to select "On", then press PUSH ENTER. "DOLBY NR" appears in the display. To return to the original setting, repeat steps 1 through 4 and select "Off" in step 4. · When recording from a CD, you can use . or > to select tracks during rec pause mode (after pressing REC PAUSE/START in step 3 and before pressing again in step 8). Recording a CD by specifying track order -- Program Edit You can record tracks from all the CDs in the order you want. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. ?/1 (Power) The CD Player Deck The Tape 2 12 x 3, 13 17 11 Multi stick PUSH ENTER 10 continued 27 Recording a CD by specifying track order (continued) 9 1 2 3 4 5 6 Place a CD and insert a recordable tape into deck B. Press FUNCTION repeatedly until "CD" appears in the display. Press MODE SELECT repeatedly to select "Set Up Mode", then press PUSH ENTER. [. . . ] model: Canadian model: European model: Dimensions (w/h/d) Mass U. S. A. model: Canadian model: European model: Supplied accessories: 120 V AC, 60 Hz 230 V AC, 50/60 Hz 190 watts 195 watts 200 watts Approx. 11. 0 kg AM loop antenna (1) FM lead antenna (1) Remote Commander (1) Batteries (2) Speaker cords (2) Front speaker pads (8) Optional accessories Surround speaker SS-SR125 Speaker system Speaker units: Full range Nominal impedance Dimensions (w/h/d) Mass 1-way, 1-unit, bass-reflex type 8 cm, cone type 16 ohms Approx. 1. 0 kg net per speaker For the customers in Canada Use only the optional SS-SR125 surround speaker for connection to the SURROUND SPEAKER connector on the MHC-ZX10. [. . . ]