User manual SONY MPK-THG

[. . . ] After recording in a location with a sea breeze, wash the marine pack thoroughly in fresh water with the buckles fastened to remove salt and sand, then wipe with a soft dry cloth. It is recommended that you submerge the marine pack in fresh water for about 30 minutes. If it is left with salt on it, metal portions may be damaged or rust may form and cause water leakage. If sun oil is on the marine pack, be sure to wash it off thoroughly using lukewarm water. [. . . ] 3 Lower the lens cover to turn on the power of the digital still camera. Be careful not to touch the lens when lowering the lens cover. Be sure to use a fully charged battery pack. Be sure that the "Memory Stick Duo" has enough space to record images. To next image To next image To next image (downward) Exit Spacer*2 Entretoise*2 *1 When using a tripod, use one screws that are 5. This equipment cannot be firmly fastened on a tripod using long screws. When using this marine pack while diving, be sure to pay attention to the surrounding situation. Lack of attention may cause an accident while diving. In case a water leakage is occurred, be sure to pay attention to the surrounding situation and surface following the safety rules for diving. Do not subject the front glass to strong shock, as it may crack. Avoid opening the marine pack at the beach or on the water. Preparation such as installing the digital still camera and changing the "Memory Stick Duo" should be done in a place with low humidity and no salty air. Do not throw the marine pack into the water. Avoid using the marine pack in places with strong waves. Avoid using the marine pack under the following situations: in a very hot or humid place. In these situations moisture condensation or water leakage may occur and damage the equipment. Use the marine pack for no longer than 30 minutes at a time in temperatures above 35 °C (95 °F). Do not leave the marine pack under direct sunlight in a very hot and humid place for a long period of time. If you cannot avoid leaving the marine pack under direct sunlight, be sure to cover the pack with a towel or other protection. The digital still camera heats up if it is used inside the marine pack for a long time. Before removing the digital still camera from the marine pack, leave the marine pack in the shade or other cool place for a while to cool down. A loose or nipped O-ring, sand or dirt on the O-ring may cause water leaks under water. [. . . ] Secure the marine pack's body, and fasten the buckle until it clicks. notes When closing the marine pack's body, make sure that there is no debris, sand, hair or any other foreign matter on the O-ring or in the seating groove. Water leakage may result if any such foreign matter is caught in these places. Before recording images underwater, first take the marine pack to a depth of about 1 m (3. [. . . ]