User manual SONY MPK-TR3 O-RING MAINTENANCE MANUAL

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] The cords are placed in the plug holders of the marine pack at the factory. Pull the plugs out of the holders when in use. Take care not to pinch the remote, microphone, and monitor cords. Be sure to check that the equipment operates correctly and that there is no water leakage before you dive (see page 20). Check that the equipment operates correctly and that there is no water leakage at a depth of about one meter (3 feet) before you dive deeper. Take care not to expose the equipment to salty air. Do not open the marine pack underwater or on the beach. Preparations such as installing and checking the equipment should be done in a place with low humidity and no salty air. Check the following points again before you dive. S Be sure to fully charge the battery pack for the camcorder. Be sure that the dry battery for the monitor is not old. The camcorder turns on and a picture appears on the LCD monitor. The REC lamp (red) lights up during recording. You cannot change the zooming speed of the camcorder. You can record a still image on a tape or "Memory Stick" by pressing PHOTO button. (Some models, however, can only record onto a tape, even if a "Memory Stick" can be inserted. ) Note that pressing PHOTO button lightly does not allow you to check the recorded image. For more details, refer to the operating instructions supplied with your camcorder. To keep a subject in focus press AUTO FOCUS ON/OFF button to set it to OFF. You can still keep the subject in focus even if fish swim between the camcorder and the subject. press AUTO FOCUS ON/OFF button again to set the camcorder to auto focus mode. Note Do not cover the control emitter or detector with your finger as the remote control signal for operations is transmitted from the grip to the marine pack. [. . . ] Even if the O-ring is not cracked or scratched, deformation or wear reduces the waterproof qualities of the O-ring. Replace the O-ring with a new one if cracking, skew, distortion, fine splitting, scratches, sand-biting, etc. You can obtain O-rings and grease at your nearest Sony dealer. The metal parts will rust and the movement of the operation switches will be impaired if you leave salt water on the marine pack. [. . . ]