User manual SONY MPK-TRA

[. . . ] Preparation such as installing the digital still camera and changing the "Memory Stick Duo" should be done in a place with low humidity and no salty air. Do not throw the marine pack into the water. Avoid using the marine pack in places with strong waves. Avoid using the marine pack under the following situations: ­ in a very hot or humid place. [. . . ] When closing the marine pack's body, make sure that there is no debris, sand, hair or any other foreign matter on the O-ring or in the seating groove. Water leakage may result if any such foreign matter is caught in these places. Buckle position when closing the marine pack's body Good example (See illustration F-41) Bad example (See illustration F-42) If you close the buckle as shown in F-42, the buckle will be caught, making it impossible to lock the marine pack. (See illustration G) Note Be careful not to pinch the hand strap when you open and close the marine pack body. Spread the LCD hood and detach it from the guide. Design and specifications subject to change without notice. If water happens to leak in, stop exposing the marine pack to water immediately. If the digital still camera gets wet, take it to the nearest Sony dealer immediately. Front glass of the marine pack has anti-fogging effect, however install the digital still camera in a low-humidity room or a similar environment. The mode is switched in the following order by turning the Mode dial. Tripod receptacle When using a tripod, use a tripod with 5. After recording in a location with a sea breeze, wash the marine pack thoroughly in fresh water with the buckles fastened to remove salt and sand, then wipe with a soft dry cloth. It is recommended that you submerge the marine pack in fresh water for about 30 minutes. If it is left with salt on it, metal portions may be damaged or rust may form and cause water leakage. If sun oil is on the marine pack, be sure to wash it off thoroughly using lukewarm water. Wipe the inside of the marine pack with a soft dry cloth. Be sure to perform the above maintenance each time you use the marine pack. Do not use any type of solvent such as alcohol, benzine or thinner for cleaning, as this might damage the surface finish of the marine pack. L-3 1 To previous image L-3 2 To next image For details, refer to the operating instructions supplied with the digital still camera. Always be sure to turn off the power when installing or removing the digital still camera. The lens may be damaged if the power is on. When storing the marine pack Attach the spacer supplied with the marine pack to prevent wear of the Oring. [. . . ] When installing the digital still camera, do it in a place that has as low a humidity as possible. Before using the marine pack, make sure that no debris has been caught between the front and back halves of the marine pack's body. Before using the marine pack, always check the number of recordable images and remaining battery life. To correct the color when this happens, use the color filter kit VF-MP5K* (optional). [. . . ]