User manual SONY MPK-TRV1

[. . . ] It is recommended that you submerge this unit in fresh water for about 30 minutes. If it is left with salt on it, metal portions may be damaged or rust may form and cause water leakage. If sun oil is on this unit, be sure to wash it off thoroughly using lukewarm water. Wipe the inside of this unit with a soft dry cloth. [. . . ] ) If you do not record any images for a certain time, the camera turns off automatically to prevent the battery pack from running out. To use the camera again, turn on the power again. for details , refer to the operating instructions supplied with the camera. When using a flash with this unit attached, the effective flash range is reduced and images tend to be darker overall, so the shooting distance may be greatly reduced in some environments (pitch dark, etc. In such conditions, it is recommended that you use an external underwater light as well as the flash. If you use the flash underwater, the flash light may be reflected by particles in the water and appear in the image as circles of light. Reflected glare may occur depending on the shooting condition. Marine Pack MPK-TRV1 (referred to below as "this unit") is exclusively for use with the Sony Digital Still Camera (referred to below as "camera") DSC-W580/ W570. (Not all cameras are available in all countries or regions. ) This unit is waterproof so the camera can be used in the rain, snow, at the beach, or underwater. Using this unit with the camera set to (Underwater), (Underwater Sweep Panorama) or (Underwater) enables you to record beautiful underwater images. If it is shut tight, changes in cabin pressure may make it difficult to open. A loose or nipped O-ring, sand or dirt on the O-ring may cause water leaks underwater. This unit's body may be scratched or water may leak if the cover is closed with sand or dirt on the O-ring or drip-proof packing. Be sure to read the separate O-ring Maintenance Manual. Important details regarding handling of the O-ring are described in this manual. You can play back images on the LCD screen using the operation button. -3 To previous image -3 To next image For details, refer to the operating instructions supplied with the camera. Be sure to turn off the power whenever installing or removing the camera. The lens may be damaged if the power is on. Install the camera in this unit in a room with low-humidity or a similar environment. Opening or closing this unit in hot or humid locations may result in fogging of the front glass. [. . . ] Notes Attach the reflex prevention ring so that its outer diameter does not stick out beyond the outer diameter of the lens surface. check the contact surface for dirt or dust before attaching the reflex prevention ring. Wipe any dust from the contact surface with a damp cloth. After using the reflex prevention ring, store it with applying on the sheet . [. . . ]