User manual SONY MS-ACMMDS

[. . . ] 3 OSS (SEL18200): Lens (1), Front lens cap (1), Rear lens cap (1), Lens hood (1), Set of printed documentation Design and specifications are subject to change without notice. Remove the rear and front lens caps and the camera body cap*. [. . . ] You can attach/detach the front lens cap in two ways, (1) and (2). When you attach/detach the lens cap with the lens hood attached, use method (2). * Some kit models do not include the camera body cap. Align the white index on the lens barrel with the white index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks. Not press the lens release button on the camera when Do mounting the lens. While holding down the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. Align the red line on the lens hood with the red line on the lens (hood index), then insert the lens hood into the lens mount and rotate it clockwise until the red point on the lens hood is aligned with the red line on the lens (hood index) and the lens hood clicks into place. Not hold by the part of the lens that protrudes when Do zooming. When using a flash, shoot at least 1m (3. With certain combinations of lens and flash, the lens may partially block the light of the flash, resulting in a shadow at the bottom of the picture. When using the lens, the corners of the screen become darker than the center. To reduce this phenomena (called vignetting), close the aperture by 1 to 2 stops. The shake compensation function is not available with the E 16mm F2. Details on setting the shake compensation function, refer For to the instruction manual supplied with the camera. [. . . ] Details on setting the shake compensation function, refer For to the instruction manual supplied with the camera. *1 The values shown above for equivalent 35mm-format focal length and angle of view are for Interchangeable Lens Cameras equipped with an APS-C sized image sensor. [. . . ]