User manual SONY MSAC-SR1

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] * The drive symbol [E:] may differ depending on your computer. The title screen will appear after a short wait. Reading the instructions carefully, proceed with the installation. PNote Read the "License Agreement" carefully, then click "Yes" if you agree. Following the on-screen instructions, click "Next" to complete the installation. " Following the on-screen instructions , install the application. Read the "License Agreement" carefully, then click "Yes" if you agree. 1 Enter your name and the name of the company for which you work. PNote If you do not have a company name to enter, enter your name instead. Close the screen, and remove the CDROM from your computer. 0a or higher) has not been installed on your computer, the "Information" screen will appear. Remove the "Memory Stick" from this unit, or turn the other device(s) off. Be sure to connect this unit directly to the USB jack of the personal computer itself. If you connect it through the USB jack of a keyboard or through a USB hub, proper operation is not guaranteed. Precautions to be taken when connecting this unit to a computer Removing the plug of the cable from its holder Grasp both sides of the USB plug to remove the end of the cable from the unit. Putting away the cable First, insert the end of the USB plug (plug A) into the unit, and then stow the rest of the cable. Fit the plug and the cable into the groove provided, the cable to fit it in. To change the position of the cable emanating from the unit Because you can change the position of the cable emanating from the unit as shown in the illustration, change it to suit the location or position of the USB hub on your computer. When using a USB hub located on the right side of a laptop computer, adjust the cable so that it comes out of the side of the unit. When the cable comes out of the side of the unit, note how the groove in the plug fits into the locking slot of the unit itself. Using the stand provided When you use the stand provided with the unit, push the unit (down) firmly until it is all the way in. Make sure the "Memory Stick" is pointed in the proper direction, then insert it into the slot in the unit. [. . . ] Doing so may damage the unit or any attached devices. Keep the following in mind when using a "Memory Stick" When the access lamp is lit, or is flashing, do not remove the "Memory Stick" from this unit. Device other than this unit is connected to the USB jack on the personal computer. T Disconnect or turn off the USB devices except this unit. [. . . ]