User manual SONY MSAC-US1

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ⭠Consult the dealer or an experienced radio/TV technician for help. [. . . ] Turn on your machine to start up Windows 98. insert the USB driver software CD-ROM (supplied) into the CDROM drive. Insert "Memory Stick" into the unit, and connect the USB jack on the personal computer to the USB jack on this unit using the specified USB cable (supplied). If the "Memory Stick" is not in this unit, you cannot install the software. The "Add New Hardware Wizard" starts twice because two drivers are installed. Do not cancel the installation midway, and complete the installation. How to use Follow the on-screen instructions until the end to install the USB driver software. Follow the onscreen instructions until the end to install the USB driver software. When you install the "Memory Stick" driver software, a message which is not described in this manual may appear on the screen. If this happens, follow the on-screen instruction. How to use When you turn on your personal computer, make sure that the "Memory Stick" is not in this unit. If the "Memory Stick" is in this unit, you may not be able to start up your personal computer. In this case, reboot your personal computer after removing the "Memory Stick" from this unit. Insert "Memory Stick" into the unit, and open "Explorer" or "My computer. How to use Folder containing still image data Folder containing E-mail data Folder containing video data Folder containing voice memo data The screen shown above is an example. Actual screen may differ according to the OS. This screen shows a window opened by Explorer. Close softwares such as Explorer running for this unit. Make sure that the access lamp is not lit, then remove the "Memory Stick. When the access lamp is lit, never remove the "Memory Stick", turn off the power of your personal computer or disconnect the connector. [. . . ] Recommended Windows environment OS: Microsoft® Windows® 98, Windows® 98SE (standard installation) Operation in a Windows® 98 environment after upgrading from Windows® 3. 1/Windows® 95 is not guaranteed. Operation in a Windows® 98SE environment after upgrading from Windows® 98 is not guaranteed. CPU: MMXTM Pentium® 200 MHz or more * The USB jack must be installed as standard. [. . . ]