User manual SONY MAVICA MVC-A7AF

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. [. . . ] to view on the TV , connect the TV as shown on page 7. Turn on the power and insert the floppy disk. " with the control button, then press To display the next image, select " " with the control button, then press it. When the indicators on the LCD screen are not displayed, press the left or right or of the Remote Commander, to side of the control button, or press display the preceding or next image. Note When the ACCESS lamp is flashing, be sure not to shake or strike the unit. Do not turn the power off or disconnect the power source. Select "INDEX" with the control button, then press it. To display the following 6 images, select "b" with the control button, then press it. ⷠTo display the preceding 6 images, select "B" with the control button, then press it. ⷠTo return to the normal playback screen (SINGLE screen), select an image with the control button, then press it. ⷠThe number displayed at the upper right side of the image shows the recording order on the disk. When the setting is finished, the menu screen disappears. Select " RETURN" or "CANCEL" with the control button, then press it. To turn off the menu screen, select " RETURN" with the control button, then press it. The unit is set to the settings marked with * (asterisk) at the factory. Select OFF if the unit operates incorrectly when using a Remote Commander of other equipment. You cannot use the supplied Remote Commander when OFF is selected. bEEP <ON*/OFF> · Select ON so that beeps sound when you press the buttons. ⷠSelect OFF to turn the beep sound off. Select SERIES to continue to number the image files sequentially from one floppy disks to another. ⷠSelect NORMAL to number the image files from 001 in each floppy disk. notes on the SERIES setting · The image files are numbered up to 999 irrespective of turning the power on/off. [. . . ] This unit's operational temperature is between 32°F to 104°F (0°C to 40°C). Do not use this unit in extreme climates such as that of a hot beach or a skiing resort. If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense inside or outside the unit. Should this occur, the unit will not operate properly. [. . . ]