User manual SONY MVE-8000

[. . . ] DME PROCESSOR PACK MVE-8000 MULTI FORMAT DME PROCESSOR MKS-8800 MKS-8810M MKS-8820M INSTALLATION MANUAL 1st Edition !WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! [. . . ] S702 (A-4) : Monitor reset switch for the COM CPU-2 Pressing this switch resets the monitor for the COM CPU-2 <Connectors> CN103 (A-4) : TERMINAL pin This pin is connected to the main CPU control terminal and used during maintenance. CN503 (A-5) : TERMINAL pin This pin is connected to the COM CPU-1 control terminal and used during maintenance. CN703 (A-5) : TERMINAL pin This pin is connected to the COM CPU-2 control terminal and used during maintenance. CN1002 (A-5) : TERMINAL pin This pin is connected to the S-BUS CPU control terminal and used during maintenance. Checks on Completion of Installation CN1003 (A-3) : ISP common connector Used only for production in the assembly factory. Used for program writing into the JTAG device with ISP. <TEST terminals> E1 (E-5), E2 (E-1), E3 (C-3), E4 (A-5), E5 (A-1) : GND terminal Use this terminal as the earth point for measuring the respective check terminals. TP001, TP002, TP003, TP004 (A-4) : Check terminal for the MAIN CPU status Terminal to check the MAIN CPU status TP501 (A-4), TP502, TP503, TP504 (A-5) : Check terminal for the COM CPU-1 status Terminal to check the COM CPU-1 status TP701, TP702, TP703, TP704 (A-5) : Check terminal for the COM CPU-2 status Terminal to check the COM CPU-2 status TP1001 (A-1) : +3. 3 V check terminal +3. 3 V measuring terminal. TP1002 (A-1) : +12 V check terminal +12 V measuring terminal. TP1003 (A-1) : +5 V check terminal +5 V measuring terminal. TP1031 (D-4) : SBUS RX check terminal S-BUS reception line measuring terminal. <LEDs on the CPU DR module> : Main CPU D10 (green) (A-1) : RUN status LED RUN status indication. Lights on when the CPU-DR module starts operating. D12 (green) (A-5) : CD (Card Detect) status LED Lights on when the CPU-DR module is inserted correctly to the parent board. D13 (green) (A-1 ) : +2. 5 V Indicates the statue of the +2. 5 V power that is generated by the VCC (CORE) and supplied to the CPU-DR module. Lights on while the specified power is turned on. D14, D15, D16, D17 (A-3) (green) : STATUS1 to STATUS4 status LED Used for maintenance purpose. Only the STATUS1 LED lights on in normal operation. 1-12 D18 (green) (A-5): +3. 3 V Indicates the statue of the VCC (I/O) power that is supplied to the CPU-DR module. Lights on while the specified power is turned on. D19 (green) (A-4) : CORE status LED Indicates the statue of the VCC (CORE) power that is supplied to the CPU-DR module. Lights on while the specified power is turned on. [. . . ] YES The system is set in the Factory Set mode?YES The MKS-8800 is suspected as defective. NO Start up the system in the Factory Set mode and check to see. NO Connect the input and output cables and equipment correctly. [. . . ]