User manual SONY MX-T2716

[. . . ] · The use of optical instruments with this product will increase eye hazard. CAUTION You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. INFORMATION This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the rear exterior. The following caution label is located inside of the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] 1/u § § 0 ) ± ± 0 ) r · P p · P p 9 Press REC r. The deck stands by for recording. INPUT AMS · P 10 Adjust the recording level, if necessary. For details, see "Adjusting the Recording Level" on page 20. 1 Turn on the amplifier and set the source selector to the position for the sound source you want to record. Insert a recordable MD. 11 Press · or P. Recording starts. 2 3 12 Start playing the sound source you want to Press INPUT repeatedly to select the input connector. To record through DIGITAL OPTICAL IN LINE (ANALOG) IN record. Select OPT ANALOG (Continued) To record from the CD player section manually Press INPUT repeatedly to select CD. 19 Recording on MDs To pause recording Press P. To resure recording, press the button again or press ·. Note Whenever you pause recording, the track number increases by one. For example, if you paused recording while recording on track 4, the track number increases by one and recording continues on the new track when restarted. Adjusting the Recording Level You can adjust the recording level before starting recording. MENU/NO AMS ?1/u § § To stop recording Press p. 0 ) ± ± 0 ) r · P p · P p z When "Overwrite" flashes in the display in Step 9 above This indicates that the deck will start recording erasing the existing material. 1/u z You can play back tracks just recorded If "TRACK" lights up in the display when recording has finished, press · immediately to play back from the first track of the material just recorded. Notes · You cannot record over the existing material when "PROGRAM" or "SHUFFLE" appears in the display. · You cannot change the recording mode setting during recording or recording pause. · You cannot operate the CD player section while the deck is recording or standing by for recording with "OPT" or "ANALOG" selected with the INPUT button. · P = < r p + > ^ + ­ 0 ) ^ LEVEL +/­ 1 2 3 4 Do Steps 1 to 9 in "Recording on an MD Manually" on page 19. Play the portion of the sound source with the strongest signal level. · Make sure that the remaining recordable time on the MD is longer than the playing time of the CD track. · The recording level specified in the Setup Menu (page 20) is not applied during REC-IT Recording. The initial reference level (0. 0 dB) is used instead. While "TOC Writing" is flashing Do not move the deck or pull out the AC power cord to ensure the complete recording. The deck is currently updating the Table Of Contents (TOC) of the MD. 22 Recording on MDs Notes Recording a CD to an MD at High Speed (High-Speed CD Synchro-Recording) This function allows you to record a CD to an MD at four times the speed of normal CD Synchro-Recording. · P CD SYNCHRO HIGH · P ?1/u § § 0 ) ± ± 0 ) r · P p · P p 1 2 3 4 Insert a recordable MD. Select the playing mode of the CD (normal play, Program Play, or Repeat Play). "CD SYNCHRO" appears and "­High­" flashes in the display. The MD deck section stands by for recording and the CD player section stands by for playing. After "CD SYNCHRO" and "­High­" turn off, press · or P on either CD player section or MD deck section. The deck stops automatically after recording. · You cannot record over existing material during HighSpeed CD Synchro-Recording. The deck automatically starts recording from the end of the exisiting material. [. . . ] If such a display appears, check the following table in order to resolve the problem. Should any problem persist, consult your nearest Sony dealer. Three-digit display/Message C11/Protected!!C12/Cannot Copy Cause/Remedy The inserted MD is record-protected. [. . . ]