User manual SONY NAC-SV10I

[. . . ] Indicates an action that the user must execute. Indicates that you should not disassemble the unit. Indicates that you should unplug the power code for safety. ­1­ WARNING " Never attempt to disassemble the unit such as opening the unit cover. Doing so may cause an electric shock or fire. [. . . ] this setting as it is at shipment. Leave ­ 10 ­ Terminator Setup (TMON) To connect this device to the end of the SCSI BUS, make sure the BUS is terminated. Otherwise, the SCSI BUS should not be terminated. Terminator 2 1 0 DC PAR TMON TMP Terminated Not terminated × : Wired with the jumper. ×: Not wired with the jumper. The terminator is disabled upon shipment. Parity Jumper (PAR) The parity jumper sets the parity function. SCSI Parity 2 1 0 DC PAR TMON TMP Parity enabled Parity disabled × : Wired with the jumper. ×: Not wired with the jumper. The parity function is set enabled upon shipment. Leave this setting as it is at shipment. Data Compression (DC) This jumper sets whether data compression is enabled or disabled. To disable the data compression function, set the function disabled with this jumper and reset the device by powering off and on. Data Compression 2 1 0 DC PAR TMON TMP Data compression disabled Data compression enabled : Wired with the jumper. × ×: Not wired with the jumper. The data compression is set enabled upon shipment. Leave this setting as it is at shipment. ­ 11 ­ Installing to the Basic Processing Unit The following describes an installation example to the basic processing unit. CAUTION Before installing this unit, make sure you unplug the power plug for the basic processing unit you are using (such as a server or workstation basic processing unit). Leaving the power cord plugged in presents an electrical shock hazard. 1 Mount Built-In DAT to the following position illustrated in the figure below. Place it in either location. 2 Connect the interface cable as illustrated in the following figure. DC Power Cable (Spare connector in the system) SCSI Interface Cable (Spare connector in the system) !Confirm that the SCSI ID, terminator, and others are appropriately set before installation. The SCSI ID of this device is set to 4 upon shipment. (The INDEX labels come with the 4mm data cartridge. ) !Attach a label to the exact position illustrated in the previous section. Remove the old label before replacing it with a new one. Use a label with the same size as the specified INDEX label when it is necessary to use a non-specified one. On the attached INDEX label, there is a field to fill in the date of first use. It will help determining the life of the 4mm data cartridge. Write-protection Placing the write-protection plug as illustrated in the right figure below protects contents of the tape. To prevent the written data from erasing, place the write-protection plug as illustrated in the right figure below. Placing the write-protection plug as illustrated in the left figure below allows the data to be written on the tape. Not write-protected Write-protected ­ 17 ­ Precautions on Handling Precautions on Use Before Use !Do not use a 4mm data cartridge on which external damage, deformation, or bending is found. To use the 4mm data cartridge stored in the environment that does not satisfy the required temperature and humidity requirements, leave it in the operation environment longer (max. 8 hours) than it has been in the above environment before use. [. . . ] Replace the cleaning cartridge with a new one. Do not reuse the old cleaning cartridge. If the same error occurs right after the cleaning, use a new data cartridge. Clean the head with the standard cleaning cartridge. [. . . ]