User manual SONY NP-55

[. . . ] Run all ground (earth) leads to a common ground (earth) point. Be sure to insulate any loose unconnected leads with electrical tape for safety. The use of optical instruments with this product will increase eye hazard. Notes on the power supply lead (yellow) · When connecting this unit in combination with other stereo components, the connected boat circuit's rating must be higher than the sum of each component's fuse. [. . . ] When no boat circuits are rated high enough, connect the unit directly to the battery. The numbers in the list are keyed to those in the instructions. Be sure to connect the ground (earth) lead before connecting the amplifier. When connecting only a single CD changer or other optional device, connect directly to this unit. For connecting two or more CD changers or other optional devices, the source selector XA-C40 (not supplied) is necessary. To AMP REMOTE IN of an optional power amplifier To the interface cable of a telephone This connection is only for amplifiers. Connecting any other system may damage the unit. If you have a power antenna (aerial) without a relay box, connecting this unit with the supplied power connecting lead may damage the antenna (aerial). notes on the control and power supply leads · The power antenna (aerial) control lead (blue) supplies +12 V DC when you turn on the tuner, or when you activate the AF (Alternative Frequency) or TA (Traffic Announcement) function. If you have any questions and problems connecting your unit that are not covered in this manual, please consult your dealer. *1 If board thickness is not enough, use the speed nut . Note If you cannot attach this unit using parts to for the board, use the tapping screw and speed nut . Choose the installation location carefully so that the unit will not interfere with normal boating or car driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. Only the front panel of this unit is water resistant. select carefully the mounting location to avoid internal damage by water entering the unit. Areas subject to water splashes should be avoided. Use only the supplied mounting hardware for a safe and secure installation. [. . . ] Areas subject to water splashes should be avoided. Use only the supplied mounting hardware for a safe and secure installation. Yellow Jaune Amarillo Gelb Geel Giallo Yellow Jaune Amarillo Gelb Geel Giallo continuous power supply alimentation continue fuente de alimentación continua permanente Stromversorgung continu voeding alimentazione continua Red Rouge Rojo Rot Rood Rosso Yellow Jaune Amarillo Gelb Geel Giallo switched power supply alimentation commutée fuente de alimentación conmutada geschaltete Stromversorgung geschakelde voeding alimentazione commutata Pay careful attention to the board material and its thickness before drilling to avoid any damage to the interior panel. Note If any modification to the boat is required, such as drilling holes, etc. [. . . ]