User manual SONY NSXD30

[. . . ] CD Stereo System NSX-D30 U C OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) OWNER'S RECORD Record the model number and serial number of your set (found at the rear of your set) below. Refer to them when contacting your Aiwa dealer. _____________________________ Serial No. _____________________________ For assistance and information (United States and Puerto Rico) 8C-NF8-903-11 011214BKH-U-FM WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS Read the Operating Instructions carefully and completely before operating the unit. [. . . ] 5 Press c. ·During programed playback, you cannot select a disc or a track with the numbered buttons. "CAN'T USE" is displayed when you try to select a track . ·If the total playback time of the program exceeds 99:59 minutes, or if a track with a track number exceeding 30 is programed, the playing time is displayed as "- -:- -". ·You cannot program more than 30 tracks. "FULL" is displayed. 11 RADIO OPERATIONS Tuning in to preset stations On the unit 1 Press TUNER/BAND to select a band. 2 Press cPRESET repeatedly or turn MULTI JOG. En With each press, the station with the succeeding preset number is tuned in. On the remote control 1 Press BAND to select a band. 2 Press the numbered buttons for the preset number of your desired station. - To select preset number 20, press +10, +10 and 0. - To select preset number 15, press +10 and 5. · Pressing PRESET N, M or c repeatedly can also select the preset number. To clear a preset station 1 Tune in to the station by preset tuning. 2 Press sCLEAR, then press aSET within 4 seconds. Preset numbers of preset stations in the band with higher numbers decrease by one. Manual tuning 1 Press TUNER/BAND (BAND on the remote control) repeatedly to select a band (FM or AM. ) 2 Press f or g to tune in to a station. "TUNE" is displayed when a station is tuned in. "1" lights up for FM stereo reception. To search for a station automatically (Auto Search) Hold down f or g. The unit searches for a station up or down the band and stops at reception. To stop the search manually, press f or g. ·Auto Search may not stop at stations with weak signals. Preset tuning Preset your favorite stations and tune them in directly. Presetting stations 1 Press TUNER/BAND to select a band. 2 Press f or g to tune in to the desired station. 3 Press aSET to store the station. The preset number, beginning from "1", appears on the display. 4 Repeat step 1 to 3 to preset other stations. ·You cannot store more than a total of 32 preset stations. "FULL" is displayed. 12 Adjustments Antennas Keep antennas away from metallic objects, electrical equipment and cords. FM antenna: Extend fully and position for the best reception. If receiving condition is poor, connect optional outdoor antenna to FM 75 terminal. Be sure to connect the shield braid of the antenna to the 2 terminal. AM antenna: Rotate to find best reception. [. . . ] Should this occur, leave the unit for a few hours, then try to operate again. Resetting the unit If an unusual condition occurs in the display window or the cassette deck, reset the unit as follows: 1 Press POWER to turn off the power. If the power cannot be turned off, disconnect the AC power cord, then plug it in again. Everything stored in memory after purchase is cleared. 20 Specifications MAIN UNIT CX-ND30 TUNER FM tuning range FM usable sensitivity (IHF) FM antenna terminal AM tuning range AM usable sensitivity AM antenna 87. 5 MHz to 108 MHz 13. 2 dBf 75 ohms (unbalanced) 530 kHz to 1710 kHz (10 kHz step) 531 kHz to 1602 kHz (9 kHz step) 350 µV/m Loop antenna 64 W + 64 W (40 Hz - 20 kHz, THD less than 1 %, 6 ohms) 80 W + 80 W (1 kHz, THD less than 10 %, 6 ohms) 0. 08 % (35 W, 1 kHz, 6 ohms, DIN AUDIO) VIDEO/AUX: 500 mV SPEAKERS: 6 ohms or more PHONES: 32 ohms or more 4 tracks, 2 channels stereo 50 Hz ­ 15 kHz AC bias DECK 1: playback x 1 DECK 2: recording/playback x 1, erase x 1 Semiconductor laser ( = 780 nm) 1 bit dual 85 dB (1 kHz, 0 dB) 0. 05 % (1 kHz, 0 dB) GENERAL Power requirements Power consumption Power consumption in standby mode Dimensions (W x H x D) Weight 120 V AC, 60 Hz 80 W With ECO mode on: 0. 6 W With ECO mode off: 17 W 260 x 324 x 315 mm (10 1/4 x 12 7/8 x 12 1/2 in. ) 6. 7 kg (14 lbs 12 oz) En FRONT SPEAKERS SX-ND30 Speaker system Speaker units 3 way, bass reflex (magnetic shielded) Woofer: 160 mm (6 3/8 in. ) cone Tweeter: 60 mm (2 3/8 in. ) cone Super tweeter: 20 mm (13/16 in. ) ceramic x 2 6 ohms 230 x 324 x 227 mm (9 1/8 x 12 7/8 x 9 in. ) 3. 8 kg (8 lbs 6 oz) AMPLIFIER Power output Total harmonic distortion Input Outputs Impedance Dimensions (W x H x D) Weight CASSETTE DECK Track format Frequency response Recording system Heads Specifications and external appearance are subject to change without notice. COPYRIGHT Check copyright laws relevant to recordings from discs, radio or tape for the country where the unit is to be used. CD PLAYER Laser D/A converter Signal-to-noise ratio Harmonic distortion 21 NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]