User manual SONY NSXD77

[. . . ] Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. Ventilation - The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm clearance from the rear and the top of the unit, and 5 cm from the each side. [. . . ] "PRGM" disappears on the display. To add tracks to the program Repeat step 2 and 3 before starting playback. The tracks are added to the end of the program. To change the programed tracks Clear the program and reselect the tracks in your desired order. Notes on CDs 2 Press CD DIRECT on the remote control and then press the numbered button (1-3) within 3 seconds to select a disc. Go to the next step when the tray stops rotating. ·Do not place more than one disc on one tray. ·Do not tilt the unit with discs loaded. ·The unit may not play a CD-R/RW disc recorded on personal computers or certain kinds of CD-R/RW recorders. ·Do not attach adhesive label, etc. to either side of a CD-R/ RW disc, as doing so may cause malfunction. ·Do not load an unrecorded CD-R/RW disc. ·Do not use irregular-shaped CDs. En 3 Press the numbered buttons on the remote control to program a track. The selected track number lights up on the display. -To select the 25th track, press +10, +10 and 5. AM antenna: Rotate to find best reception. To switch to monaural FM reception Press SHIFT+TUNER MODE on the remote control. With each press, "MONO" and "STEREO" are displayed alternately on the display. En Tip: When FM stereo reception is poor, switching to monaural reduces noise. To switch the AM tuning interval Hold down TUNER/BAND and press POWER on the unit. With each press, the AM tuning interval alternates between 9 kHz/ step and 10 kHz/step. Tip: The default is 10 kHz/step. Change it only when using the unit in a 9 kHz/step area. Switching AM tuning interval clears all the preset stations. 13 TAPE OPERATIONS To play back type II (High position) tapes Turn MULTI JOG until "SOFT" is displayed while playing a type II tape. Then, the unit provides the optimum playback sound for type II tapes. Notes on cassettes En ·Use of 120-minute or longer tapes is not recommended since they are extremely thin and easily deformed or damaged. ·Take up any slack in the tape with a pencil or similar tool before use. ·"SOFT" sound for type II tapes described above is canceled when the cassette holder is opened, the function is changed, or the unit is turned off. Playback Use only type I (normal) tapes. 1 Press TAPE/DECK 1/2 and insert the tape in either deck. Press zPUSH EJECT to open the cassette holder, and insert with the exposed side down and playback side facing out from the unit. Push zPUSH EJECT to close. To stop playback Press s. To pause playback (DECK 2 only) Press a. [. . . ] ·Is the erasure prevention tab of the tape broken off?If so, cover the detection slot with adhesive tape. ·Is the lens affected by condensation?If so, wait approximately one hour and try again. En Condensation Moisture may form on the CD pickup lens when: ·The unit is moved from a cold spot to a warm spot ·The heating system has just been turned on ·The unit is used in a very humid room ·The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. [. . . ]