User manual SONY NSXTR77

[. . . ] CD Stereo System NSX-TR77 U OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) OWNER'S RECORD Record the model number and serial number of your set (found at the rear of your set) below. Refer to them when contacting your Aiwa dealer. _____________________________ Serial No. _____________________________ For assistance and information (United States and Puerto Rico) 8C-NFT-903-01 020520AKH-U-BF WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS Read the Operating Instructions carefully and completely before operating the unit. [. . . ] to either side of a CD-R/ RW disc, as doing so may cause malfunction. ·Do not load an unrecorded CD-R/RW disc. ·Do not use irregular-shaped CDs. En 4 Repeat step 2 and 3 to program other tracks. 5 Press c. ·During programed playback, you cannot select a disc or a track with the numbered buttons. "CAN'T USE" is displayed when you try to select a track. ·If the total playback time of the program exceeds 99:59 minutes, or if a track with a track number exceeding 30 is programed, the playing time is displayed as "- -:- -". ·You cannot program more than 30 tracks. "FULL" is displayed. 11 RADIO OPERATIONS Tuning in to preset stations On the unit 1 Press TUNER/BAND to select a band. 2 Press cPRESET repeatedly or turn MULTI JOG. En With each press, the station with the succeeding preset number is tuned in. On the remote control 1 Press BAND to select a band. 2 Press the numbered buttons for the preset number of your desired station. - To select preset number 20, press +10, +10 and 0. - To select preset number 15, press +10 and 5. ·Pressing PRESET M, N or c repeatedly can also select the preset number. To clear a preset station 1 Tune in to the station by preset tuning. 2 Press sCLEAR, then press aSET within 4 seconds. Preset numbers of preset stations in the band with higher numbers decrease by one. Manual tuning 1 Press TUNER/BAND (BAND on the remote control) repeatedly to select a band (FM or AM. ) 2 Press f or g to tune in to a station. "TUNE" is displayed when a station is tuned in. "1" lights up for FM stereo reception. To search for a station automatically (Auto Search) Hold down f or g. The unit searches for a station up or down the band and stops at reception. To stop the search manually, press f or g. ·Auto Search may not stop at stations with weak signals. Preset tuning Preset your favorite stations and tune them in directly. Presetting stations 1 Press TUNER/BAND to select a band. 2 Press f or g to tune in to the desired station. 3 Press aSET to store the station. The preset number, beginning from "1", appears on the display. 4 Repeat step 1 to 3 to preset other stations. ·You cannot store more than a total of 32 preset stations. "FULL" is displayed. 12 Adjustments Antennas Keep antennas away from metallic objects, electrical equipment and cords. FM antenna: Extend fully and position for the best reception. [. . . ] Do not leave tapes near magnets, motors, television sets, or any source of magnetism. Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight. Troubleshooting If your unit fails to perform properly, check the following guide and the relevant sections of the Operating Instructions. There is no sound. ·Are the speakers and AC power cord connected properly?·Possibly a short circuit in the speaker terminals. [. . . ]