User manual SONY NW-S202F

[. . . ] Be sure to install the "SonicStage" software from the supplied CD-ROM in your computer. * Depending on the country/region in which you have purchased the player, some models may not be available. You can charge the player's battery by connecting the player to your computer with the supplied USB cable. Make sure to charge it before using the player for the first time. [. . . ] When the remaining battery indication of the display shows , charging is complete. When you use the player for the first time, or if you have not used the player for a long time, recharge it fully, and then transfer the data to the player. Do not disconnect the USB cable while data is being transferred. Do not leave the player connected for extended periods to a laptop computer that is not connected to AC power, because the player may discharge the computer's battery. You can create and transfer playlists that group your favorite songs into a list. for details , refer to SonicStage Help. To delete songs of the player, use the SonicStage software on your computer. When the G Sensor menu is deactivated in Sleep status, the player consumes very little battery power. Skip to the beginning of the next album/artist. Skip to the beginning of the next album/artist, and if held longer, continues to skip through the next album/artist(s). Skip to the beginning of the current album/artist, and if held longer, continues to skip through the previous album/artist(s). When starting playback, appears at the bottom left of the display, and if the button is pressed again, appears and playback stops. When you press the button, just after purchasing the player or after disconnecting the supplied USB cable from the computer, playback starts from the first song on the player. hint There is no power button on the player. When you stop song playback or FM reception (NW-S202F/S203F/S205F only) by pressing the button, after about a few seconds, the display goes off automatically and the player enters Sleep status. In this case, if you press any button, the player returns to the previous status. When you press this button while the player is in play or stop mode, you can change the display. To operate the player with the shuttle switch To Operation Normal mode (In play mode) Skip to the beginning of Rotate the shuttle switch the next song. Normal mode (In stop mode) Skip to the beginning of Rotate and hold the the next song, and if held shuttle switch to . Longer, continues to skip through the next song(s). Skip to the beginning of Rotate and hold the the current song, and if shuttle switch to . Held longer, continues to skip through the previous song(s). [. . . ] When Music Pacer is activated, the "Walk Music" or "Run Music" playlist is played back in shuffle mode, depending on your pace of movement. Playlists for "Walk" and "Run" are preinstalled into the player. You can also create playlists using the SonicStage software on your computer. Hint In Preset Tuning, you cannot select broadcast stations if no preset stations are entered. [. . . ]