User manual SONY VAIO PCG-FRV37 HARD DISK DRIVE REPLACEMENT INSTRUCTIONS

[. . . ] Intel and Pentiumare registered trademarks and Centrino is a trademark of Intel Corporation or its subsidiaries in the United States and other countries. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows. PCMCIA is a trademark of the Personal Computer Memory Card International Association. [. . . ] If ad hoc connection is in use, "Ad hoc (Peer-to-peer)" will be displayed. Security The setting status of WEP is displayed. Speed The communications speed is displayed. Band (Frequency) The current operating frequency band is displayed. When communication is possible, "802. 11b (2. 4 GHz)" is displayed. Channel The channel number currently being used for the communications is displayed. 3. Enter the sharing printer name in[Share name]. Click the [OK] button. Confirming connection After you have finished the network setup operations, access the folder whose sharing has been set for other personal computers. Also, confirm the status of the radio waves in case of trouble such as a network connection failure. POINT In the case of infrastructure connection, enter the necessary data for the access point before confirming connection. Refer to the manual of the access point for the access point setup procedure. Connecting your personal computer to another personal computer 1. Noise The shorter the bar graph, the less noise, resulting in a better the radio wave signal. 60 W I r e l e s s L A N U s e r 's G u id e Connection using Windows 2000 FLOW OF OPERATIONS The wireless LAN connection procedure is outlined below. Make sure that the personal computer is ready for the transmission of radio waves from the wireless LAN. For further details, see "Starting the transmission" on page 54. Assign the parameters required for wireless LAN connection. For further details, see "Preparation for wireless LAN connection" on page 55. POINTS Wireless channels 1 to 11 are used for the IEEE802. 11b-compliant wireless LAN adopted by this personal computer. If you are to use infrastructure connection (network connection via a access point), a channel number greater than 11 may have been preassigned or automatically assigned to the wireless channel to be used for the access point. In such a case, set the channel of the access point to either from 1 to 11. For further details of the setting method, refer to the manual of the access point you are using. 2. Enter the network name (SSID) and other data. Enter the network key (the key to be used to encode communications data). 3. Perform setting operations relating to network connection. For further details, see "Connection to the network" on page 57. To use infrastructure connection, refer to the manual of the access point for the access point-setting procedure. In the case of infrastructure connection, to use ADSL (PPPoE) for accessing the Internet, the MTU size of this personal computer needs to be changed. [. . . ] UL Underwriters Laboratories ­ An independent organization that tests and certifies the electrical safety of devices. An external bus standard that allows for fast data transfer. A single USB port can be used to connect up to 127 peripheral devices, such as mice, modems, and scanners. USB 1. 1 has a transfer speed of a maximum of 12Mb/s. [. . . ]