User manual SONY VAIO PCG-GR290K DATASHEET

[. . . ] Instead, send the computer to the service center for repair. Plug (either one) Foot Continue with the procedure, matching the replacement foot to either plug on the bottom case. © 2003 Apple Computer, Inc. D Procedure Warning: The glue used in this procedure can bond instantly to skin. [. . . ] In the event of contact, review the safety instructions at the end of this document. For additional information, refer to the glue manufacturer: Elmer's Products, Inc. Place the computer upside down on a clean, lint-free cloth or other nonabrasive surface. Make sure the plug area on the bottom case is clean. If any portion of the soft rubber foot remains, remove it so that only the hard plastic plug is visible (as shown with both types of plugs below). Important: Notice the recessed hole in the center of the plug. When positioning the foot, make sure the raised bump on the textured plane of the rubber foot fits into the center hole in the plug. Using the end of the tweezers or pliers--not your finger--lightly press and hold the foot in place for 30 seconds. 7. Before turning over the computer, allow the glue to set for at least 15 minutes. Discard the tube of glue. SAFETY INSTRUCTIONS: GLUE IS AN EYE AND SKIN IRRITANT. If eye or mouth contact occurs, hold eyelid or mouth open and rinse thoroughly but gently with water only for 15 minutes and GET MEDICAL ATTENTION. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor. If skin bonding occurs, soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). [. . . ] If skin bonding occurs, soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may cause skin burn. [. . . ]